Functions; Setting The Time And Date - Trotec BZ05 Manuel D'utilisation

3 .0 functIons

3 .1 settIng the Date anD tIme
Mode button:
(keep the mode button pressed for a short while to
change the settings)
Press once: Minutes
Press twice: Hours
Press 3 times: 12/24 hr display
Press 4 times: Month
Press 5 times: Day
ADJ – button
Memo – button

Setting the time and date

You can read both the time and the date on your hygro-
meter. The time appears permanently in the upper third
of the display. This display is changed by briefly pressing
the [ADJ] button: the date appears with month (left) and
day (right).
B - 3 opeRating instRuctions - Room theRmo-hygRometeR BZ 05
In order to reset the time and/or the date, proceed as
follows:
Press and hold the [MODE] button for a short while. The
minute display starts to flash. Press the [ADJ] button to
adjust the minute display.
Press the [ADJ] button once to adjust the minute display
each time by one minute, or keep it pressed in order to
reach a particular number of minutes faster. After that,
press the [MODE] button once to access the hour and
date settings. This is done in the same way. After going
through all values (min/hr/month/day) once, the new va-
lue is stored.
Your appliance has both a 12-hr and a 24-hr display. In
the case of the 12 hour display, the abbreviations „AM"
(from 00:00 to 12:00) and „PM" (from 12:00 to 24:00)
additionally appear to the left of the time.
the new value is automatically saved after
m
one minute. the display stops flashing.