Urmet Yokis MTR500E-UP Mode D'emploi page 8

Timer
Configuration duration
Upon exiting the factory, timing is not active.
All configurations are preserved in the absence
of mains voltage.
25 short presses are required to set the duration
in seconds (from 2 seconds to 240 seconds).
To return to a duration in minutes, one must
push briefly for 26 times.
Automatic network creation
NB: Connection to the receiver network can take between 5 and 20 seconds
Adding a module to a network
NB: Connection to the receiver network can take between 5 and 20 seconds
8/21
Extended duration
Upon exiting the factory, the extended duration
is deactivated.
To activate the extended duration function, push
briefly for 34 times.
Pressing the connected button for more than 3
seconds switches the light on for 12 hours.
To switch off, just push briefly; this will also
disable the extended duration.
Shutdown warning
Upon exiting the factory, the warning is switched
off.
To activate the warning, push briefly for 24
times.
In this way, 60 seconds before the switch-on time
expires, if it has been configured in minutes,
or 10 seconds, if it has been configured in
seconds, the light flashes briefly.
If the button is pushed briefly for another time,
the light timing is reactivated.