Safety Instructions - Brew Monk 057.701.25 Mode D'emploi

1. Safety Instructions

• Read all the instructions carefully and keep this manual for future reference.
• Do not use the device if the cord or plug is damaged; it should be replaced before use.
• The machine is intended for use only with 220-240 V and 50/60 Hz. Do not use an adaptor as
the wattage power of this device is high.
• Avoid overloading the electric supply.
• If the device requires extra power, do not use multi-outlets of under 13 A, and do not connect
any other device to this outlet.
• Check the product's rating label and make sure its voltage is fit for your outlet voltage before
use.
• The device must only be used as intended. It must be operated safely and correctly under fault-
free conditions. Ensure to check the proper conditions prior to each use.
• The appliance is only to be installed in locations where it is supervised.
• Do not splash any electronic parts of the machine.
• Do not immerse the machine in water.
• Store the machine in a dry place, do not plug it in when not in use.
2. Heating Preparation
• The device must be positioned on a stable, secure and horizontal support structure prior to use.
• A full vessel contains boiling hot liquids and can weigh up to 35 kg.
• The device may not be moved during the heating process. The handles are only meant for
transporting the device in an empty state.
• It is imperative to keep children and animals away from the device while it is in operation.
Remember boiling water is very dangerous.
• Always clean all the parts of your brewing equipment, hygiene is imperative to get good brewing
results.
• Before use, it is advisable to heat a quantity of hot water in the boiler to clean the brewing
equipment by using a proper cleaning agent (Chemipro
2.1 Before Using the Brew Monk Sparge Water Heater
We advise to rinse the machine with 5 litres of water.
1. Make sure the ball valve is closed.
2. Plug in the device and pour in 5 litres of water.
3. Turn on the power.
4. Set the temperature to 55°C
5. Add cleaning agent (Chemipro
6. Clean the kettle using a soft cloth.
7. When programme is done, switch off the pump and dispose of the hot water using the ball
valve.
You are now ready to use the Brew Monk Sparge Water Heater.
Instruction Manual Brew Monk Sparge Water Heater - EN
Wash).
®
Wash).
®
9