Sauder River Ranch 430049 Instructions D'assemblage page 16

Step 12
1
G
D44
å
Pull the DRAWER FRONT BRACKETS (8G) apart and slide them
into the grooves in the UPPER DRAWER SIDES (D44 and D45).
You may need to gently tap them in with a hammer.
å
NOTE: The DRAWER FRONT BRACKETS are marked "RH" and
"LH" for easy identification.
å
Fasten the UPPER DRAWER FRONT (G) to the DRAWER FRONT
BRACKETS (8G). Use four BLACK 9/16" LARGE HEAD SCREWS (1S).
3
M67
M67
G
Surface with
HIDDEN CAM
å
Push one HIDDEN CAM (1F) into the DRAWER BRACE (M67).
Then, insert the metal end of a CAM DOWEL (2F) into the
HIDDEN CAM.
å
Fasten the DRAWER BRACE (M67) to the UPPER DRAWER
FRONT (G). Tighten one HIDDEN CAM.
Page 16
Push down
8G
D45
BLACK 9/16" LARGE HEAD SCREW
(4 used in this step)
1F
Arrow
2F
1
Hidden part using
recycled material.
Color may vary.
2
D44
1S
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
å
Slide the DRAWER BOTTOM (D985) into the
grooves in the UPPER DRAWER
SIDES (D44 and D45) and DRAWER FRONT (G).
4
Metal end
D44
å
Fasten the UPPER DRAWER BACK (D179) to
the UPPER DRAWER SIDES (D44 and D45) and
DRAWER BRACE (M67). Use five BLACK 1-9/16"
FLAT HEAD SCREWS (30S).
430049
1
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
U n
D985
fi n
i s h
e d
s u
r f a
c e
G
Start each screw a few turns before
completely tightening any of them.
30S
BLACK 1-9/16" FLAT HEAD SCREW
(5 used in this step)
D179
M67
D45
www.sauder.com/service
11
D45
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.