Publicité
Les langues disponibles
Les langues disponibles
6
Attach the LED light
1.
The LED light has been pre-installed on the shelf. Remove the nylon cable ties bundled at both ends of the LED light,
and removed the plastic bag.
2. Insert the power cable into the end of the LED xture, and reposition so it's centered on the shelf.
Note: The back of the LED xture is magnetic and attaches directly to the holder under the shelf.
3.
Use the Cable clips (II) to attach the power cord from the LED light and route the wire along the backwall to either
the USB in the Hutch or the H61MWC15HP cabinet.
Magnet
II
Nylon cable
Double-sided tape on back
9
Please contact 1-888-HD-HUSKY
HUSKYTOOLS.COM
for further assistance.
Publicité
