Publicité
Les langues disponibles
Les langues disponibles
5
Attach the hutch to the riser
1. Place the Hutch on the Riser after the wood top is installed.
2. Open the Hutch door.
3. Use 4 pcs M6*48mm ange bolts (CC) in the 4 corners and tighten with a 8mm socket or wrench.
4.
Using a 3/32 in. drill bit, pre-drill 5 holes into the wood top along the pegboard backwall. Be careful to only drill
1 in. deep.
5.
Using an 8mm socket, install 5 pcs. ST5.5*25mm wood self-tapping screws (DD) into the pre-drilled holes in the
wood top along the rear of the pegboard. Be careful not to overtighten.
CC
8
DD
Publicité
