Home Decorators Collection 52-BETL Guide D'utilisation Et D'entretien page 11

Assembly - Hanging the Fan (continued)
8
Mounting the fan-motor assembly
(standard mount)
WARNING: When using the standard ball/downrod mounting,
the tab in the ring at the bottom of the mounting bracket
must rest in the groove of the hanger ball. Failure to properly
seat the tab in the groove could cause damage to the wiring.
NOTE: The magnet is pre-attached on the canopy bottom
cover for you to remove and install easily.
□
Align the locking slots of the canopy (C) with the two screws
(DD) and alignment post (KK) in the mounting bracket (A).
□
Push up the canopy (C) and turn clockwise until the align-
ment post (KK) engage to the round hole and the screws
(DD) engage to the key slots.
□
Firmly tighten the two mounting screws (DD).
□
Align the oval shape on the canopy (C) with canopy bottom
cover (FF), Push up the canopy bottom cover (FF) until the
screw (DD) heads engage to the slots on the canopy bottom
cover (FF) so that the magnetic canopy bottom cover (FF)
can be attached to the bottom of the canopy (C) properly.
Assembly - Attaching the Blades
1
Attaching the fan blades
□
Attach a blade (F) to the fan-motor assembly (E) by inserting
the blade (F) into the slots in the side of the fan motor housing
and aligning the three screw holes in the blade with the holes
in the center flywheel and secure with screws (AA).
□
Make sure all the screws are firmly tightened.
□
Repeat these steps for the remaining blades.
11
Please contact 1-800-986-3460 for further assistance.
KK
E
F
AA
A
DD
C
B
FF
E
HOMEDEPOT.CA