Home Decorators Collection 52-BETL Guide D'utilisation Et D'entretien page 12

Assembly - Attaching the Light
1
Attaching the light kit pan
□
Remove one screw (OO) from the black bracket below fan
motor assembly (E), and loosen, but do not remove the other
two screws.
□
Push the light kit pan (G) up to the black bracket so that the
two loosened screw heads fit into the keyhole slots. Turn the
light kit pan (G) clockwise to secure.
□
Re-install the screw (OO) that was removed in step 1.
□
Make sure all the screws are firmly tightened.
2
Attaching the light kit fitter assembly
CAUTION: To reduce the risk of electric shock, disconnect
the electrical supply circuit to the fan before installing the
light fixture.
□
Remove one screw (LL) from the light kit pan (G), and loosen,
but do not remove the other two screws.
□
Connect the wires from the light kit fitter assembly (H) to
the wires from the fan motor assembly (E) by connecting the
molded adaptor plugs together. Carefully tuck all wires and
splices into the switch cup.
□
Push the light kit fitter assembly (H) up to the light kit pan (G)
so that the two loosened screw heads fit into the keyhole slots.
Turn the light kit fitter assembly (H) clockwise to secure.
□
Re-install the screw (LL) that was removed in step 1.
□
Make sure all the screws are firmly tightened.
3
Installing the shatter resistant shade
CAUTION: Make sure the power is off before attaching or
removing the shatter resistant shade.
WARNING: Allow the shatter resistant shade to cool
completely before removing.
WARNING: To prevent breaking of the shatter resistant
shade and to avoid personal injury, hand tighten all parts in
order. Do not use any tools to tighten the nut or finial.
□
Remove the finial nut (PP) from the threaded nipple of the
light kit fitter assembly (H).
□
Position the shatter resistant shade (I) over the threaded
nipple.
□
Re-install the finial nut (PP) to secure the shatter resistant
shade (I) properly.
H
12
E
G
OO
G
LL
G
H
I
PP