Ninja THIRSTI WC1000C Serie Manuel D'instructions page 4

SETTING UP YOUR NINJA THIRSTI™ DRINK SYSTEM CONT.
REMOVING THIRSTI FLAVORED WATER
DROPS
1
Lower the Flavor Carriage to open.
2 Remove the Flavored Water Drops and snap
cap into the closed position.
NOTE: Flavored Water Drops have a shelf life
of 30 days once opened.
NOTE: It is recommended to store Flavored
Water Drops in a cool, dark place to further
maintain aroma, color, and taste.
5 5
ninjakitchen.ca
CO LOW WARNING
2
When the button turns orange, there is
approximately 25% CO remaining, or enough
2
for approximately 25 350 mL drinks. The
button will remain orange until a new CO
2
canister is installed and the indicator is reset.
Once a new CO canister has been installed,
2
reset the indicator by pressing and holding the
button for 3 seconds or until it turns from
orange to white.
NOTE: Only reset the indicator when a new
canister has been installed.
NOTE: Only use Ninja Thirsti CO
Canisters for
2
best carbonation results.
REPLACING CO CANISTER
2
1 Open the CO door at the back of the unit
2
and swing out the CO canister.
2
2 Slowly twist the CO canister to the left until it
2
releases from the unit.
3 Follow the installation directions to install a
new CO canister.
2
4 Press and hold the button for 3 seconds.
When the button illuminates white or a beep
is heard, the CO has been reset to accurately
2
notify when carbonation is running low.
NOTE: Only use Ninja Thirsti CO Canisters.
2
USING THE CONTROL PANEL
5
1
3
USING YOUR NINJA THIRSTI™ DRINK SYSTEM
SETUP CHECKLIST
1
Ninja Thirsti Drink System is plugged in.
2 CO is tightly installed.
2
3
The reservoir is filled with cold water and placed on the docking station.
4 Desired Flavored Water Drops are installed.
5
Always place a vessel on the drip tray when dispensing water.
GET STARTED DRINK MAKING
1 Press button to toggle between Low, Medium, or High Sparkling.
2
Press button to select 180 mL, 350 mL, 530 mL, or 710 mL dispense volume.
3 Press the button or button to toggle through No Flavor (0 LEDs illuminated),
Classic Flavor (1 LED illuminated), and Bold Flavor (2 LEDs illuminated) strengths.
4 Press
button to start drink making.
5 The Beverage Dispense Light will turn on while the beverage is dispensing. Once the beverage is
complete, the light will turn off and an audible end tone will be heard.
6 Do not open the Flavor Carriage or move the unit during a cycle process.
NOTE: Combining two flavors is NOT available when 180 mL dispense size is selected.
NOTE: Always empty the drip tray bucket before or as soon as the orange "full" indicator appears.
2
1
Sparkling Strength Button
* Number of Sparkling levels
will vary by model
6
2
Size Button
3
Flavor 1 Strength Button
4
4 Flavor 2 Strength Button
5
Start Button
6
Drain
When "drain" is blinking,
press "Start" button
to proceed
6 6
ninjakitchen.ca