Ninja THIRSTI WC1000C Serie Manuel D'instructions page 3

PREPARING FOR FIRST USE
BEFORE FIRST USE
1
Remove and discard any packaging material,
stickers, and tape from the unit.
2
Pay particular attention to operational
instructions, warnings, and important
safeguards to avoid any injury or property
damage.
3 NEVER put the Ninja Thirsti base unit in
TM
the dishwasher.
4 Place the Ninja Thirsti base on a stable, flat
surface and plug in.
Do not overfill the water reservoir.
Fill water only to the fill lines.
SETTING UP YOUR NINJA THIRSTI DRINK SYSTEM
SETTING UP NINJA THIRSTI DRINK SYSTEM
Scan here to watch a video on setting up your
Ninja Thirsti Drink System.
INSTALLING CO CANISTER
2
1 Open the CO door at the back of the unit.
2
3 3
ninjakitchen.ca
RINSE CYCLE
1
Place 350 mL cup on the hinged cup tray or
bottom drip tray.
2 Fill the water reservoir with cold filtered
water and place on Water Reservoir dock.
3 Select STILL by toggling the button
until the light below "Still" is illuminated.
4 Press the
button to select 350 mL
dispense size.
5
Ensure Mixing Chamber is installed into
Flavor Carriage and in raised position.
6 Press the "Start" button to start the
Rinse Cycle.
7 Dispose of the dispensed water once the
Rinse Cycle is complete.
2
Swing the CO cover out of the unit.
2
3 Remove tamper seal and black cap from
CO canister before installing.
2
4 Insert the CO canister into the CO cover.
2 2
Applying gentle pressure, turn to the right
until tight.
5 Press CO canister into unit. Close the door.
2
Hand-tighten only. Do not use tools.
SETTING UP YOUR NINJA THIRSTI™ DRINK SYSTEM CONT.
HOW DO I KNOW CO IS PROPERLY
2
INSTALLED?
1
Canister cannot be turned anymore.
2
Carbonation is present in Sparkling drinks.
3
There is no hissing sound from the back of
the unit when making a sparkling drink.
PREPARE WATER RESERVOIR
1 Fill water reservoir with ice and cold, filtered
water.
TIP: Filtered water guarantees a clean, clear taste.
2
Do not overfill the water reservoir. Fill water
only to the fill lines
3 Place water reservoir on the Water Reservoir
dock. Measurement gradients should face
forward when properly installed.
NOTE: Check the Cold Water Indicator at the
bottom of the reservoir. The brighter the blue,
the colder the water, the fizzier the drink.
TIP: Store Water Reservoir in fridge when not
in use.
INSTALLING THIRSTI FLAVORED WATER
DROPS
Flavored Water Drops bottles are designed to be
interchangeable between drinks for endless drink
customization.
INSTALL
1
Remove safety seal.
2 Flip the cap into the open position. The cap
will click into place on the backside of the
Flavored Water Drops bottle.
OPEN
3 Lower the Flavor Carriage to open.
4 Flip the Flavored Water Drops so the nozzle
is down and gently insert it into the Flavor
Carriage. An audible click indicates proper
installation.
5
Repeat with a second Flavored Water Drops
bottle if a combo beverage is desired.
6 Raise the Flavor Carriage to close.
ninjakitchen.ca
4 4