Publicité
Les langues disponibles
Les langues disponibles
EMPLOYER'S RESPONSIBILITIES
Employer must enforce compliance with the safety warnings and all other
instructions contained in this manual.
Keep this manual available for use by all people assigned to use this tool.
For personal safety and proper operation of this tool, read and understand
tool labels and manual. Failure to follow warnings could result in DEATH or
SERIOUS INJURY. Read and follow all of these instructions carefully.
FUNCTIONAL DESCRIPTION
Porter-Cable Model RN175A is a heavy duty, coil fed, pneumatic roofing
nailer. It is designed to install .120" diameter, 15° wire collated roofing nails
7
3
of various lengths from
" to 1
" long.
/
/
8
4
Use approved Porter-Cable fasteners only.
POWER SOURCE
This tool is designed to operate on clean, dry, compressed air at regulated
pressures between 70 and 120 PSI (Pounds per Square Inch)(4.8 to 8.3 BAR).
The preferred system would include a filter, a pressure regulator, and an
automatic oiler located as close to the tool as possible, within 15 ft/4.6 m is
ideal.
All compressed air contains moisture and other contaminates that are
detrimental to internal components of the tool. An air line filter will remove
most of these contaminates and significantly prolong the life of the tool. If an
in-line oiler is not available: place five or six drops of Porter-Cable Air Tool Oil
into the tool's air inlet at the beginning of each workday.
1
3
The tool is equipped with a
" male "quick connector". A
" male "quick
/
/
4
8
connector" is available from Porter-Cable and may be used in situations where
1
3
a
" supply line is not available. A
" supply line (and fittings) are required for
/
/
4
8
maximum tool performance. The tool must always be connected to the air
supply with a coupling such that all pressure is removed from the tool when the
coupling is disconnected.
7
Publicité
