Porter Cable RN175A Manuel D'instructions page 13

Disconnect tool from air supply before performing any Service
Procedure.
SYMPTOM
1. Air leak near top of
tool or in trigger area.
2. Tool does nothing or
operates sluggishly.
3. Air leak near bottom
of tool.
4. Tool jams frequently.
5. Other.
A complete line of accessories is available from your Porter-Cable • Delta
Supplier, Porter-Cable • Delta Factory Service Centers, and Porter-Cable
Authorized Service Stations. Please visit our Web Site www.porter-cable.com
for a catalog or for the name of your nearest supplier.
Cable • Delta, have not been tested with this product, use of such
accessories could be hazardous. For safest operation, only Porter-
Cable • Delta recommended accessories should be used with this
product.
TROUBLESHOOTING
PROBLEMS
Loose screws.
Worn or damaged
o-rings or seals.
Inadequate air supply.
Inadequate lubrication.
Worn or damaged
o-rings or seals.
Loose screws.
Worn or damaged
o-rings or bumper.
Incorrect fasteners.
Damaged fasteners.
Magazine or nose
screws loose.
Magazine is dirty.
Driver is worn or damaged.
ACCESSORIES
Since accessories, other than those offered by Porter-
SOLUTIONS
Tighten screws.
Install Overhaul Kit.
Verify adequate air supply.
Put 5 or 6 drops of oil into air inlet.
Install Overhaul Kit.
Tighten screws.
Install Overhaul Kit.
Verify approved fasteners of
correct size.
Replace w/undamaged fasteners.
Tighten screws.
Clean magazine.
Install "DRIVER" Maintenance Kit.
Contact a Porter-Cable
Service Facility.
13