DeLonghi SFG1031 Mode D'emploi page 4

Thank you for choosing this De'Longhi heater. To get the very best out of your new heater it is
advisable to read these instructions before using it. This will ensure that you gain optimum results
and use the appliance safely.
General instructions
Your stove is designed for use throughout your living area, such as against a wall or in a corner. To
add instant warmth and ambiance.
Position the stove so that the electrical outlet is accessible.
Always ensure there is sufficient unobstructed airflow in the front of the stove, otherwise the operation
of the stove will be compromised.
Placing the pebbles/coal
Depending on which stove you have purchased you will find pebbles or coal packed with your stove.
In order to place the pebbles/coal on the shelf within the stove you will need to open the door.
Once the stove is placed in your chosen location, unpack the pebbles/coal from the accessory box.
The pebbles/coal are natural; therefore variation in size, shape and color will occur.
Arrange the coal/pebbles as you wish using as many as you require.
If your stove has pebbles, we suggest spreading the smaller ones across the shelf as a base. The 3
large pebbles should then be placed on top with the medium ones used to fill any gaps where light
could escape.
Operating the stove
The stove is controlled by a slider
Off Flame Effect only Minimum power Maximum power
Slider
Turning on the Flame Effect
The Flame Effect pattern can operate with or independently from the heat.
Heat Levels
For minimum heat, set the slider on the minimum power position I.
For maximum heat, set the slider on the maxmum power position II.
The Flame Effect will always operate when the heat is on.
Adjusting the thermostat
When the room reaches desired temperature, turn the thermostat knob counter clockwise very slowly
and carefully until you hear a "click". This will automatically set your unit to cycle on and off at that
desired heat setting.
Automatic Safety Shut Off
This heater is equipped with an automatic shut off to prevent any damage due to overheating. The
heater will automatically shut off if the airflow is obstructed. To reset the stove, disconnect the plug
from the power socket for a few minutes, remove the cause of obstruction and allow a suitable cooling
period before plugging it in again.
4 4