Bosch MUM Serie Manuel D'utilisation page 33

Note: The swivel arm will only open
or close with the inserted tool when
the drive is located in the correct
parked position.
The following causes result in an
incorrect parked position:
¡ The power supply was interrupted
during processing.
¡ A safety system terminated pro-
cessing.
¡ During processing the swivel arm
disengaged or the release button
for the swivel arm was pressed.
Tip: You can easily adjust an incor-
rect parking position yourself.
→ "Troubleshooting", Page 38
5.7 Safety systems
You can find an overview of your ap-
pliance's safety systems here.
Start lock-out
Start lock-out prevents your appli-
ance from being switched on acci-
dentally.
The appliance can only be switched
on and operated if the swivel arm
has engaged correctly in position 1
or position 3.
Restart lock-out
Restart lock-out prevents your appli-
ance from automatically restarting
processing after a power failure.
The appliance is switched on again
after a power failure. Processing can-
not start again until the rotary switch
has been set to
Overload protection
The overload protection system pre-
vents the motor and other compon-
ents from being damaged through
being overloaded.
⁠ .
Before using for the first time en
Before using for the first time
6 Before using for the
first time
Prepare the appliance for use.
Before using for the first time
6.1 Preparing the appliance
Press the release button and raise
1.
the swivel arm until it engages.
→ "Moving the swivel arm",
Page 33
Lift and remove the bowl.
2.
→ "Removing bowl", Page 34
Clean all parts that come into con-
3.
tact with food before using for the
first time.
→ "Cleaning and servicing",
Page 36
Put the cleaned and dried parts
4.
out ready for use.
Basic operation
7 Basic operation
Basic operation
7.1 Cable length
Adjust the length of the power cable
to your needs.
Adjusting cable length via cable
storage compartment
Pull the power cable out to the re-
1.
quired length.
To shorten the cable, push it into
2.
the cable storage compartment.
7.2 Moving the swivel arm
Press the release button and raise
1.
the swivel arm until it engages.
→ Fig.
3
a The swivel arm is fixed in posi-
tion 2.
33