Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION INSTRUCTIONS
FEATURES
1. Beer Tower
2. Rubber Gasket (may not be
required in all installations)
3. Guard Rail
4. Drip Tray
5. Thermostat dial
6. Keg Coupler
7. Beer Keg (not included)
8. Metal Support Plate
9. Casters
10. CO
Regulator
2
11. CO
Tank
2
12. CO
Tank Support
2
BEFORE USING YOUR KEG COOLER
• Remove the exterior and interior packaging.
• Check to be sure you have all the following
parts:
• 2 guard rails
• 1 drip tray (2 pieces)
• 1 CO
tank support
2
• 1 CO
regulator
2
• 1 CO
tank (empty)
2
• 2 CO
gas line hose (coloured)
2
• 2 beer hose
• 2 beer keg couplers
• 1 beer tower
• 2 faucet handles
• 1 metal plate for cabinet bottom
• 3 wire shelves
• 2 steel clamps for coloured hose
• 2 plastic washers for front casters
• 4 casters (2 front with locks)
Note: This appliance includes an American Sankey
tap coupler only.
INSTALLATION LOCATION
• Place the appliance on a fl oor that is strong
enough to support it when it is fully loaded.
• Do not place the appliance in direct sunlight or
near sources of heat, such as a stove or heater,
as this can increase electrical consumption.
Extreme cold ambient temperatures may also
cause the appliance to perform improperly.
• Do not use the appliance near water, for
example in a wet basement or near a sink.
• This appliance is intended for indoor use only. It
is not designed for outside installation, including
anywhere that is not temperature controlled
(garages, porches, vehicles, etc.).
• Before connecting the appliance to a power
source, let it stand upright for approximately
6 hours. This will reduce the possibility of a
malfunction in the cooling system from handling
during transportation.
• This appliance is intended for free-standing
installation only and is not intended to be
built into a cabinet or counter. Building in this
appliance can cause it to malfunction.
5
Publicité
