Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION INSTRUCTIONS
INSTALLATION OF THE CO
Attach the end of the coloured air line hose to the hose connection on the side of the coupler. Ensure that
the reed valve is inserted into the connection, number 4 on the image below.
If, after assembly, beer will not fl ow, ensure that the reed valve has a small hole in it. If there is no hole in
the reed valve then CO
CONNECTING THE BEER TOWER TO THE COUPLER
• Ensure all washers are properly inserted into the
coupler, as per the below image.
• Ensure the check valve is in place inside the
coupler, number 2 on the below image.
• Place the wing nut attached to the end of the
beer line into the top of the coupler, turning until
tight.
If, after assembly, the beer is
very foamy, it most likely means
that a connection in the coupler
is leaking and air is entering
the lines. Double check all
connections in the coupler and
replace the washers from the
accessory bag as necessary.
INSTALLATION OF THE KEG COUPLER
Insert the keg coupler into the locking neck of the
beer keg and turn it clockwise to lock into position,
making sure the keg coupler handle is in the closed
position, with the handle up.
1. Coupler pressure release valve
2. Handle in closed position
AIR LINE HOSE
2
cannot enter the line and the beer will not fl ow.
2
1. Valve washer
2. Check valve
3. O-type washer
4. Reed valve
5. Valve washer
6. Valve washer
1
10
2
Publicité
