• Between uses, the heater should be stored with the control knob in the
OFF position and the LP source disconnected.
• The heater should be stored in an upright position in a sheltered area away
from direct contact with inclement weather (such as rain, sleet, hail, snow,
dust and debris).
• If desired, cover the heater to protect the exterior surfaces and help
prevent build-up in air passages. NOTE: Wait until the heater has
completely cooled to the the touch before covering.
• Only a qualified service person should repair gas passages
and associated components.
TROUBLESHOOTING
PROBLEM
Burner won't light Propane cylinder
Burner flame
is low
Carbon
build-up
or thick
black smoke
26 | www.bluesk youtdoorliving.com
POSSIBLE CAUSES
is frosted over
Blockage in orifice
Control knob is not
in the ON position
Gas pressure is low
Outdoor temperature is
less than 40 °F (5 °C) and
tank is less than 1/4 full
Control knob fully ON
Dirt or film on reflector
and burner screen
Blockage in burner
CORRECTION ACTIONS
Wait until the propane
cylinder warms up and
is defrosted
Clear blockage
Turn control knob to ON
Turn cylinder valve OFF
and replace cylinder
Use a full cylinder
Check burner and orifices
for blockage
Clean reflector and
burner screen
Remove blockage and clean
burner inside and outside