Blue Sky Outdoor Living PHG8732BZ Manuel Du Propriétaire page 16

STEP 9: REFLECTOR ASSEMBLY
WARNING
Remove the protective film from
parts A and B before assembling.
Secure all fastening hardware loosely
and tighten when reflector assembly is
properly aligned.
Slide two reflector panels [A] together.
Insert one M6 x 10 screw [HH] into the
reflector panels. Slide one 6 mm washer
[GG] over the threaded end of the screw,
then screw on one cap nut [II].
GG HH
STEP 10
Put the reflector plate [B] in the center
of reflector panels.
Slide in the third reflector panel [A].
Insert one M6 x 10 screw [HH] into
each reflector panel. Slide a 6 mm
washer [GG] over the threaded end
of each screw, then loosely screw on
a cap nut [II].
Attach the reflector plate to the three
reflector panels using six M6 x 10
screws [HH], 6 mm washers [GG]
and cap nuts [II].
Fully tighten all screws.
GG HH
16 | www.bluesk youtdoorliving.com
II
A
II
A
II
GG
HH
B
II
GG
HH