Listening To The Radio - Teac SR-80i Mode D'emploi

1
Press the FUNCTION button repeatedly to
select "FM" or "AM".
< You can also select "FM" or "AM" by pressing the
BAND button once or twice.
2
Select the station you want to listen to.
Automatic tuning
Hold down the TUNING button and release it
when the automatic tuning process starts. When
a station is tuned in, the tuning process will stop
automatically.
Repeat this step until the station you want to listen to
is found.
< To stop the automatic tuning process, press the
TUNING button briefly.
Manual tuning
Press the TUNING button repeatedly.
The frequency changes by a fixed step.
Press repeatedly until the station you want to listen
to is found.
24

Listening to the Radio

Hold down
FM Mode
When the source is "FM", pressing the FM MODE
button alternates between stereo mode and mono
mode.
Stereo
"Stereo" appears on the display for a few seconds, and
then it will turn to "ST".
When a program is broadcast in stereo, you hear stereo
sound. When in monaural, you hear monaural sound.
< If the sound is distorted, the signal is not strong
enough for good stereo reception. In this case,
change to mono mode.
Mono
"Mono" appears on the display for a few seconds, and
then it will turn to "MO".
To compensate for weak FM stereo reception, select
this mode. Reception will now be forced into monaural,
reducing unwanted noise.
If the reception is poor
For the best reception, rotate the FM antenna or AM
antenna until you get stations clearly (pages 6 - 7 ).
E F
,