Taurus STEAKMAX 2500 Mode D'emploi page 6

English
Flat grill
STEAKMAX 2500
DESCRIPTION
A Grill with non-slip treatment
B Temperature selector
C Pilot light
D Connector
E Connector input
F Base
G Handles
USE AND CARE:
- Fully extened the appliance's power cable
before each use.
- Do not move the appliance while in use.
- Do not use the appliance if it is tipped up and do
not turn it over.
- Do not turn the appliance over while it is in use
or connected to the mains.
- Do not cover the cooking surface or food with
aluminium foil and other similar materials.
- Do not cover or wrap the food with aluminium
foil and other similar materials.
- To keep the non-stick treatment in good condi-
tion, do not use metal or pointed utensils on it.
- Disconnect the appliance from the mains when
not in use and before undertaking any cleaning
task.
- Store this appliance out of reach of children
and/or persons with physical, sensory or
reduced mental or lack of experience and
knowledge.
- Do not store the appliance if it is still hot.
- Do not store the appliance on areas where the
temperature could be lower than 2ºC
- Never leave the appliance connected and un-
attended if is not in use. This saves energy and
prolongs the life of the appliance.
- Turn the thermostat control to the minimum
(MIN) setting. This does not mean that the appli-
ance is switched off permanently.
INSTRUCTIONS FOR USE
BEFORE USE:
- Make sure that all products' packaging has
been removed.
- Before using the product for the first time, clean
the parts that will come into contact with food in
the manner described in the cleaning section.
- Some parts of the appliance have been lightly
greased. Consequently, the first time the appli-
ance is used a light smoke may be detected.
After a short time, this smoke will disappear.
USE:
- Extend the cable completely before plugging it
in.
- Ensure that the electronic connector is properly
attached to the appliance.
- Connect the appliance to the mains.
- Turn the thermostat control to the desired tem-
perature position.
- The pilot light (c) comes on.
- Wait until the pilot light (c) has gone out which
will indicate that the appliance has reached an
adequate temperature.
- During the appliance's use the pilot light (c) will
come on and off automatically, indicating the
heating elements are working, and therefore
maintaining the desired temperature.
- When the food is to your taste, remove it from
the appliance with the help of a wooden spatula
or similar heat resistant implement; do not
use utensils that could damage the non-stick
coating.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Select the minimum position (MIN) using the
thermostat control.
- Unplug the appliance from the mains.
- Clean the appliance.
SAFETY THERMAL PROTECTOR:
- The appliance has a safety device, which pro-
tects the appliance from overheating.