Nakamichi Cassette Deck 1.5 Mode D'emploi page 6

Tape 1/Tape 2 selector
To System Remote output connector i
SS= 35 SSS = Ses oS > Jo AC wall outlet
m
=)
2 =
a
To Tape Out L (white)
and R (red) jacks
Preamplifier, amplifier, or receiver
& For remote control of the cassette deck from another
Nakamichi audio component
1. Connect the System Remote cable.
Connect the System Remote Tape 1 or Tape 2 output jack
of a Nakamichi component equipped to serve as control
center to the System Remote jack on the cassette deck.
2. Set the Tape 1/Tape 2 selector.
Set the selector to "Tape 1" if the Tape 1 output was used
and to "Tape 2" if the Tape 2 output was used.
| Before changing the setting of the Tape 1/Tape 2 selector,
be sure to turn the unit's power switch off.