Zippity Madison Instructions D'assemblage page 3

1
S T E P O N E
Assemble the Gate Frame
1
Orientate the posts so the tab is facing up as illustrated.
Insert the post down through the top and bottom horizontal
rails as illustrated.
Tab
Note that the underside of the bottom rail only has two holes
as shown.
2
Align the pre-drilled holes in the horizontal rails with the
pre-drilled holes in the vertical posts and fasten together with
FOUR short screws for the bottom and top rail.
3
Starting with one inside corner, place the corner bracket
against the horizontal and vertical posts as shown.
4
Note: Underside of bottom rail.
Fasten corner bracket with two short screws into the horizontal
rail.
2
5
Fasten with two more screws into the vertical posts.
6
Repeat for all four inside corners.
Align
3 4 5
3
M a d i s o n Vi n y l G a t e K i t w / F e n c e Wi n g s I n s t r u c t i o n s