Publicité
Les langues disponibles
Les langues disponibles
1 Automatic safety systems
Door opening safety:
Your machine's door will be locked when
the wash cycle has started.
When the cycle is completed or when the
machine has stopped with the tank full of
water, the door unlocks immediately. If you
have programmed a "Delayed end", the
door is not locked throughout all the walting
period preceding the start of the cycle.
If you want to open the door during the
cycle, press briefly on
" 1-1 " button and
wait 1 or 2 minutes for the door safety to
unlock.
balance"). In this case, your wash may be
insufficiently spun. So spread your wash
uniformly around the drum and programme
a new spin.
Anti-foam safety system:
Your washing machine knows how to
detect when too much foam is produced,
during spin cycle, LCD display shows fol-
lowing messages 'Excess of detergent" or
"Request of a rinse more.
At that time the spin stops and the machine
is drained.
Then the cycle re-starts, using a more
Depending on the time in the cycle when
appropriate spin rate and adding, where
you want to open the door, this time can
necessary a supplementary rinse.
be longer since there will be a cooling
period added to it.
The End time is changed.
During this cycle the door safety will not
Reduce your doses of detergent during the
unlock unless the interior temperature is
following washes.
below 60°C, and this is to prevent you
from being seriously scolded.
Tap closed
Water safety:
The continuous water level control will pre-
vent any overflow duirng operation.
Spinning safety:
Your washing machine is equipped with
a safety system which can limit spinning
when the load is incorrectly distributed
(this incorrect distribution is called "Out of
When you can read on LCD display follow-
ing messages "Open tap" or "Press Start",
, this shows that there is a blockage in the
water supply of your machine,
- check if the water supply tap is indeed
open,
- check if the water supply tube is not bent
or kinked.
i tests.
-, -'
-#
--
.
-l
...
---'
' -......
For the display written on the energy label, the tests are made in accordance with European Directive 92/75/CEE at
nominal capacity ensuring the total use of the CEI detergent from the start of the wash phase.
®
21
Programme
Temperature
60°C
Load
7 kg
Duration
Ph 10
Energy consumption
... 1,19 kWh
Water
.491
Publicité
