Bort TITAN 7000 Mode D'emploi page 11

GB ENGLISH
INSTALLATION INSTRUCTIONS, MAINTENANCE
AND USING THE DISPOSER
Before installing the product, read everything care-
fully. Installation, maintenance and use manual. Be-
fore starting work determine which tools, materials,
and equipment you need.
Before installing the disposer, make sure that you
have all the necessary parts of the product.
REQUIRED TOOLS AND MATERIALS:
screwdriver, Hinged pliers, insulation tape, protece -
tive glasses
REQUIRED INSTRUMENTS, MATERIALS AND
OPTIONAL EQUIPMENT:
a Phillips screwdriver, a drainage drill, electrical
terminal 9.5 mm, threaded nuts (2), siphon 38 mm,
drill 32 mm, hammer, hacksaw, water hose clamp,
pipe pliers, copper grounding wire, dishwasher
drainage pipe kit, electric switch, extension pipe
1. DESCRIPTION OF THE PRODUCT (FIG.1.1)
Assembly unit
1. Stopper;
2. Washing flange;
3. Rubber gaskets (2);
4. Support ring;
5. Mounting ring;
6. Screws;
7. Locking ring;
8. Sound attenuating screen;
Disposer
9. Installation gasket / protective reflector;
10. Eyelets;
11. Lower mounting ring;
12. Drain the dishwasher;
13. Outlet opening;
Drainage system
14. Mounting Screws;
15. Rubber gasket;
16. Flange;
17. Drain pipe with a knee;
18. Siphon.
2. DISCONNECTION OF THE DROP HORN AT-
TENTION!
At the time of installation of the device is
recommended Wear safety glasses. Loosen the
nut (1) on the top of the water trap (4) with a pipe
wrench (Fig. 3.1). relative humidity not more than
80%. Loosen the nut (2) on the top of the extension
pipe. Remove the extension pipe.
Loosen the nut (3) at the bottom of the washing
flange.
Push the washing flange upwards through drain
hole of the sink and remove it (Fig. 3.2).
CLEAN THE WASH FAN WRAPPING PLACE FROM THE
SEALANT OR THE GARBAGE.
NOTE: It may be necessary to expand the drain
hole for installation flange fastening disposer.
Equipment for extending the drainage hole is
purchased separately.
3. DISASSEMBLY OF THE ASSEMBLY UNIT
• Turn over the assembly (Fig.4.1) and loosen the
three fixing screws (1) The access to the ring (2).
• Disconnect the retaining ring from the flange
with a screwdriver. Now the assembly unit can be
disassembled.
4. ATTACHING THE FIXING ASSEMBLY TO WASH-
ING Fig.5.1.
ATTENTION! To install the disposer, the thickness of
the sink in the area of the drain hole should be no
more than 18 mm.
1. Install one or two rubber gaskets (2) under the
washing flange (1). Make sure that The drainage
hole is not clogged, and set to flange washer /
gasket. In order to The flange of the sink became in
place, you need to crush it with a heavy load. (To
avoid scratches, use a towel as a lining.)
2. Put the second rubber part on the bottom of
the kitchen sink a gasket (2), a cardboard gasket
(optional) (3) and a metal support ring (4) (flat side
up).
3. While holding the second rubber gasket,
cardboard padding (optional) and a metal support
ring, put the mounting ring (5) on the flange of the
sink so that it aligned with the support ring.
4. Pressing tightly to the bottom of the sink
rubber gasket, cardboard gasket, support ring and
mounting ring, slide the snap ring (7) onto the
11