Steba WK 10 Mode D'emploi page 13

Getting started
∙ Unwind the cable from the cable storage und plug it in.
∙ Open the lid, fill the device with water and close the lid.
∙
Do not fill the above the maximum marking on the water gauge because
hot water can escape.
∙ Place the container onto the base.
∙ Press the ON/OFF button, the blue LED shines.
∙ The device starts with the 100°C mode and starts heating.
∙ The temperature indicator displays the water temperature. Once the desired tem-
perature is reached, the boiling process can be stopped with the ON/OFF switch.
The temperature indicator is out of order if there is less water as MIN in the device.
Troubleshooting
Dear Client,
Thank you for buying this STEBA product. The following table will help you with
problems that may occur when using your device. For many problems there is a sim-
ple solution, because not everything that appears like a malfunction must be serious.
Please check the following list before contacting our customer service.
Problem
Control light does not
shine once device is
plugged in
Boiling result is bad
Device turns off
Reason
∙ No power
∙ To many devices at one
power cord
∙ Lid is not closed prop-
erly
∙ Heating plate is calci-
fied
∙ Due to scale, heat ac-
cumulates and triggers
the microswitch
Solution
∙ Check is plug is
plugged-in correctly
∙ Check the fuse
∙ Close the lid
∙ Decalcify the device
∙ Leave to cool for 10
minutes.
∙ Descale
13