Hoftronic TWINKLE10 Mode D'emploi page 2

Les langues disponibles

IMPORTANT SAFETY DETAILS

This product must be installed by a qualified electrician in accordance with instructions provided and in compliance with recognised electrical

and safety regulations relevant to the country it is being installed.

This product may NOT be installed by minors or people with a mental disability.

This product must be installed to the current edition of the IEE wiring regulations and relevant building regulations in your country.

This product is designed for outdoor use.

IMPORTANT DETAILS

Put the switch in the ON position when the ambient brightness is lower than 10LUX; the light string will automatically light up;

It can be charged in the sun regardless of whether the switch is placed in the ON or OFF state;

If it's not been used for a long time, please charge the product every three months;

Please use this product away from fire.

Please put the solar panel in direct sunlight for at least 8 hours to have a full charge. It will need longer to be charged on cloudy or winter

days. Make sure the panel is not sheltered and is placed horizontally.

Solar panel has a built-in light sensor to control the lights to turn it on/off; please make sure there is no other light source shining on the solar

panel to affect the bulb's flicker or turn on at night.

When the solar panel's light sensor detects its surroundings' brightness is ≥30Lumens, the light will turn off automatically. When the

surrounding brightness is ≤10 Lumens, the lights will turn on automatically.

This solar light has a mode memory function. When the light is turned off in a specific mode, next time, it will turn on the lights in the same

mode automatically.

INSTALLATION DETAILS

Connect the solar panel to the string light

Turn on

Press Mode for 8 different mode selection

a. Combination -> Waves -> Sequential -> Slow Flow -> Flashing -> Slow Fade -> Twinkle -> Steady on

TROUBLESHOOTING

The lamp does not turn on

a. The lamp is off -> Make sure the lam is turned on by pressing the on/off button on the backside of the solar panel

b. The battery is not sufficiently charged -> Turn off the lamp and leave it off for at least 2 sunny days to allow the batteries to fully

recharge.

c. The lamp is hanging in an environment that is too bright -> Place the lamp in a dark environment.

d. The solar panel is dirty -> Clean the solar panel with a damp cloth.