Refco RESCALE 4688292 Mode D'emploi page 13

Tank Capacity
It is often convenient to know the relative amount of gas remaining in a
gas cylinder (tank). The REFSCALE Tank Capacity Mode allows a continuous
display of the percentage of gas remaining in a tank. In order to compute
the percentage accurately, the REFSCALE must be trained with the weights
of an empty and full tank. To train the REFSCALE Tank Capacity Mode,
perform the following steps:
1. While holding
will show on the display. This indicates that the Tank Capacity Mode is
currently off.
2. Turn the Tank Capacity Mode on by pressing
and the Alternate Numeric Display and Percent Indicator will turn on.
to proceed to the first step of training. 0% will flash in the
3. Press
Alternate Numeric Display indicating that the weight of an empty container
must be registered.
4. Apply an empty container (or a load representing the weight of an empty
container) on the platform. Wait 5 seconds for the load to stabilize, then
press . 00 % will flash in the Alternate Numeric Display indicating
that the weight of a full container must be registered.
5. Apply a full container (or a load representing the weight of a full container)
on the platform. Wait 5 seconds for the load to stabilize, then press
This completes the training process, and the SET TANK indicator will turn
off.
6. From this point forward, the Alternate Numeric Display will show the
percent of material remaining in the container from 0 % to 100 %.
press . The SET TANK indicator will turn on, and OFF
. The display will show ON,
REFSCALE Instruction Manual
EN
.
| 13