Ninja BN650 Instructions page 23

6 Plug in the unit, then press the Power
button to turn it on . Select LOW .
The disc will begin spinning .
7 Add the ingredients you want to slice
or grate through the feed chute on the
lid . Use the food pusher to help guide
the ingredients through the feed chute .
The middle piece of the food pusher is
removable to use for smaller ingredients .
8 When fi nished, stop the unit by touching
the Power button and wait for the disc
to stop spinning . Press the button on the
feed chute lid near the handle to unlock,
then turn the lid anti-clockwise . Lift the lid
from the bowl .
44 ninjakitchen.eu
9
Using the fi nger holes, carefully lift the
disc out of the bowl .
10 Grasp the spindle by the top of the
shaft and lift it out of the bowl .
11 To remove the bowl from the motor
base, turn the bowl anti-clockwise
and then lift it .
12 Press the Power button to turn the unit
off , then unplug the unit . Refer to the
Care & Maintenance section for cleaning
and storage instructions .
CARE & MAINTENANCE
CLEANING
Separate all parts . Wash bowl in warm,
soapy water with a soft cloth .
• Hand-Washing
Wash bowl, lid, disc, and blade assemblies
in warm, soapy water . When washing
the blade assemblies, use a dishwashing
utensil with a handle to avoid direct hand
contact with blades .
Handle blade assemblies with care to
avoid contact with sharp edges . Rinse
and air-dry thoroughly .
• Dishwasher
All attachments are dishwasher safe . It
is recommended that the bowl, lid, disc,
and blade assemblies be placed on the
top rack of the dishwasher ONLY . Ensure
the blade assembly is removed from the
bowl before placing in the dishwasher .
Exercise care when handling blade
assemblies .
• Motor Base
Turn off the unit and unplug the motor
base before cleaning . Wipe motor base
with a clean, damp cloth .
DO NOT use abrasive cloths, pads,
or brushes to clean the base .
STORING
Wrap the power cord around the cord
wrap on the back of the motor base .
Store the unit upright and store all blade
assemblies inside or attached to the bowl
with the lid locked in place .
DO NOT stack items on top of the
containers . Store any remaining
attachments alongside the unit or in a
cabinet where they will not be damaged
or create a hazard .
RESETTING THE MOTOR THERMOSTAT
This unit features a unique safety system
that prevents damage to the motor and
drive system should you inadvertently
overload the unit . If the unit is overloaded,
the motor will be temporarily disabled .
Should this occur, follow the reset
procedure below .
1 Unplug the unit from the socket .
2 Allow the unit to cool for approximately
15 minutes .
3 Remove the bowl's lid and blade
assembly . Empty the bowl and ensure
no ingredients are jamming the blade
assembly .
IMPORTANT: Ensure that maximum
capacities are not exceeded . This is the
most typical cause of appliance overload .
ORDERING REPLACEMENT PARTS
To order additional parts and attachments,
visit ninjakitchen.eu
ninjakitchen.eu
45