Philips BC 8310 Mode D'emploi page 6

XP SBC BC 8310/00-1.1
Installation
Transmitter power supply
IMPORTANT
Use only Philips SBC CS030/00 12 Volt/
200 mA AC/DC adapter
1 Make use of the Philips SBC HC 8372 FM
wireless transmitter.This transmitter can be
purchased separately.
2 Make sure the adapter's rated voltage
corresponds to the mains socket voltage.
3 Connect the DC connector of the AC/DC
adapter to the 12 Volt DC power input
connector located at the rear of the
transmitter.
4 Connect the 12 Volt/200 mA AC/DC
adapter to the mains socket.
– Always disconnect the AC/DC adapter if
the transmitter is not to be used for a
long period of time.
Speaker power supply
IMPORTANT
Use only rechargeable LR6/AA NiCd
batteries (preferably Philips).
Do not use alkaline batteries as
these may damage your FM wireless
system!
1 Remove the isolating sheet from the
battery compartment.
Environmental Information
All redundant packing material has been omitted.We have done our best to make the
packaging easily separable into two materials: cardboard and polyethylene
Your unit consists of materials which can be recycled if disassembled by a specialized
company. Please observe the local regulations regarding the disposal of packing
materials, exhausted batteries and old equipment.
6
20-08-2001 13:44
All manuals and user guides at all-guides.com
2 Check if the power button of the
3 When the sound quality of the FM speaker
4 During charging, the green charge indication
5 During operation, the remaining battery
Pagina 6
FM speaker is in the on position.
degrades, it indicates that the batteries are
running low.
– To recharge the speaker's built-in
rechargeable LR6/AA NiCd batteries,
connect to the 9 Volt/1000 mA AC/DC
adapter.
LED will light up. As soon as the batteries
are fully charged, the green charge
indication LED will switch off.
energy is indicated by the battery condition
indicator. 3 levels indicate the condition of
the rechargeable batteries.
– 3 LED's = batteries full,
– 2 LED's = batteries half full,
– 1 LED = batteries empty.
Notes:
Completely flat batteries need approximately
16 hours to recharge.
Always remove the batteries if the speaker
is not to be used for a long period of time.
Batteries contain chemical substances,
so they should be disposed of properly.