Joyello JOY PAPPA Mode D'emploi page 9

5. Lower the backrest and turn the booster seat upside down (Fig.5). Run the harness "E" from the
right to the left side as Fig.5 and Fig.5b. Follow the sequence from Fig.%c to Fig.5f to insert harness
"E" on both right and left side of the seat.
6. Please the booster seat on the center of the chair and make sure that the
chair is larger than the booster seat ase (30 cm width, 31 cm depth, 43 cm
height).
WARNING: before using the product, make sure the booster seat is correctly fixed on the
chair to prevent it from moving.
7. Adjust the height of the booster seat and then use harness "E"
to loop under the seat and lock the buckle (Fig.7a). Pull the end
of the harness to tighten (Fig.7b).
8. Use the backrest locking harness "D" to loop around at
back of the chair and lock the buckle (Fig.8a). Pull the
end of the harness to tighten it (Fig.8b).
GB
9