Publicité
Les langues disponibles
Les langues disponibles
English
Fig. D
3. With magazine fully open insert fasteners. Points must
be against bottom of magazine.
Fig. E
4. Push magazine forward.
5. Continue pushing until magazine release lever
is engaged.
Actuating Tool
WARNING: To reduce the risk of injury, Always wear
proper eye [ANSI Z87.1 (CAN/CSA Z94.3)] and hearing
protection [ANSI S12.6 (S3.19)] when operating
this tool.
The tool can be actuated using one of two modes:
single sequential action trigger mode and bump action
trigger mode.
Sequential Action Trigger -
Trigger (Fig. A)
The sequential action trigger's intended use is for
intermittent fastening where very careful and accurate
placement is desired.
To Operate the nailer in sequential Action Mode
1. Depress the contact trip firmly against the work surface.
2. Pull the trigger.
WARNING: A fastener will be driven each time the
trigger is pulled as long as the contact trip remains
depressed which could result in accidental driving.
Bump Action Trigger -
(Fig. A)
The bump action trigger's intended use is for rapid
fastening on flat, stationary surfaces.
6
6
5
Gray
Black Trigger
Using the bump action trigger, two methods are available:
place actuation and bump actuation.
To Operate the Tool Using the Place
Actuation Method
1. Push the contact trip against the work surface.
2. Pull the trigger.
3. Release the trigger and allow the tool to recoil off
the workpiece.
To Operate the Tool Using the Bump
Actuation Method
1. Pull the trigger.
2. Push the contact trip against the work surface. As long
as the trigger is pulled, the tool will drive a fastener
every time the contact trip is depressed. This allows the
user to drive multiple fasteners in sequence.
WARNING: Do not keep trigger pulled when tool is
not in use.
Adjusting Depth (Fig. F)
WARNING: To reduce risk of serious injury from
accidental actuation when attempting to adjust
depth, ALWAYS:
•
Disconnect the tool from the air supply.
•
Avoid contact with trigger during adjustments.
The depth that the fastener is driven can be adjusted using
the depth adjustment next to the trigger of the tool.
1. To drive the fastener shallower, rotate the depth
setting wheel
11
to the right.
2. To drive a fastener deeper, rotate the depth setting
wheel
11
to the left.
Fig. F
Clearing a Jammed Nail (Fig. A, G, H)
WARNING: Disconnect the tool from the air supply
and remove fasteners from magazine before making
adjustments or personal injury may result.
If a nail becomes jammed in the nosepiece, keep the tool
pointed away from you and follow these instructions
to clear:
1. Disconnect the tool from the air supply lever.
2. Release magazine release lever
11
6
from behind nails.
Publicité
