Télécharger Imprimer la page

Texas A/S BC335D Manuel D'utilisation page 27

Publicité

Les langues disponibles
  • FR

Les langues disponibles

PROBLEM
Engine starts, runs
and accelerates, but
will not run in idle.
Cord cannot be
extended.
Grass getting twisted
around drive shaft
and cord housing.
Cord spool hard to
turn.
16. Specifications
Gears
Handlebar
Weight (kg)
Carburetor
Engine (cc)
Start
Fuel
Fuel tank capacity (L)
Oil
Trimmer cord thickness (mm)
Length with blade (cm)
Spark plug
Blade
Trimmer head
Because of continued product development, Texas A/S reserves the right to improve the
product without obligation, to improve already sold models.
POSSIBLE CAUSE
Carburetor needs
adjustment.
1. Cord melted.
2. Insufficient cord on
spool.
3. Cord worn down.
4. Cord tangled with
spool.
5. Engine RPM too low. Advance cord at full throttle.
1. High grass being cut
at ground level.
2. Trimmer used at low
RPM.
Threads dirty, damaged
or full of grass.
NHSP AL6RC / CMR6A (part no. 412906)
SOLUTION
Contact repair shop.
Replace. Trimmer operating too close to
stones and walls.
Fit more cord.
Advance cord while alternatively pressing
and releasing cord housing.
Remove cord from spool, roll on once
more.
Cut grass from top and down.
Use trimmer at high RPM.
Clean threads, lubricate with grease.
Replace spool if necessary.
BC335D
Automatic centrifugal clutch
V handle
8.1
Membrane type
33.5
Recoil
Octane 95
0.6
SAE30 / SAE10W-30 - 50 ml
2.4 mm
190
3-toothed
Tapn'go 2 cord
27

Publicité

loading