Télécharger Imprimer la page

Texas A/S BC335D Manuel D'utilisation page 26

Publicité

Les langues disponibles
  • FR

Les langues disponibles

14. Storage (Important)
IMPORTANT!
If the brush cutter is stored for more than 4 weeks, it is recommended to drain all fuel from
the tank into an approved container. You can also let the engine run until the tank is
completely empty and the engine stops. Push several times on the primer to get the last
fuel out before machine is set for storage.
During storage over the vinter time, it is recommended also to empty the oil tank
completely.
Always store the brush cutter in a horizontal position (place it on a surface)!
Clean the trimmer for grass and dirt and store it in frost-free conditions out of the reach of
children. Observe all safety instructions concerning safe storage and handling of gasoline.
15. Troubleshooting
PROBLEM
Engine will not start
Engine starts, but
will not accelerate
Engine starts, but
will only run at full
throttle with half
choke.
Engine will not reach
full speed and
produces a lot of
smoke.
Never re-use old gasoline and oil!
POSSIBLE CAUSE
1. No spark.
2. No fuel.
3. Engine flooded.
4. Starter cord requires
more effort than when
new.
Carburetor needs
adjustment.
Carburetor needs
adjustment, repair or
cleaning.
1. Check fuel.
2. Air filter dirty.
3. Carburetor needs
adjustment.
SOLUTION
Check spark plug. Remove spark plug,
connect lead and place plug on cylinder
block. Pull starter cord. Check for spark.
Repeat process with new spark plug if no
spark appears.
Press fuel pump button. If problem recurs,
contact dealer/repair shop.
Remove spark plug, turn trimmer over so
that spark plug hole points downwards.
Set choke to "Run" and pull starter cord
10 – 15 times. Clean spark plug. and
screw back on. Replace if necessary.
Pull starter cord 3 times with choke set to
"Run". If engine fails to start, set choke to
"Choke" and perform normal start
procedure. If engine still fails to start,
repeat procedure with a new spark plug.
Contact dealer/repair shop.
Contact repair shop.
Contact repair shop.
Use new fuel.
Clean or replace.
Contact repair shop.
26

Publicité

loading