Fein KBH25 Mode D'emploi page 13

OBJ_BUCH-0000000027-002.book Page 13 Thursday, July 21, 2011 9:04 AM
en Original Instructions for Core Drill.
Symbols, abbreviations and terms used.
Symbol, character Explanation
Do not touch the rotating parts of the power tool.
Observe the instructions in the text or graphic opposite!
Make sure to read the enclosed documents such as the Instruction Manual and the General
Safety Instructions.
Before commencing this working step, pull the mains plug out of the socket. Otherwise there
will be danger of injury if the power tool should start unintentionally.
Use eye protection during operation.
Use ear protection during operation.
Gripping surface
Additional information.
Confirms the conformity of the power tool with the directives of the European Community.
This sign indicates a possible dangerous situation that could cause severe or fatal injury.
WARNING
This sign warns of a possible dangerous situation that could cause injury.
CAUTION
Worn out power tools and other electrotechnical and electrical products should be sorted
separately for environment-friendly recycling.
Product with double or reinforced insulation
Low speed
High speed
Cutting spray
Tool holder
Character Unit of measure,
international
P W
1
P W
2
U
V
f
Hz
n /min
0R
n /min
0L
M... mm
Ø mm
mm
Fe
mm
Al
mm
mm
kg
Unit of measure, Explanation
national
W Power input
W Output
V Rated voltage
Hz Frequency
rpm No-load speed (clockwise)
rpm No-load speed (anticlockwise)
mm Size of metric thread
mm Diameter of a round part
mm Drilling capacity in steel (core drill bit)
mm Drilling capacity in aluminium (core drill bit)
mm Drilling capacity (hole saw)
mm Tap
kg Weight according to EPTA-Procedure 01/2003
en
13