Publicité
Les langues disponibles
Les langues disponibles
> Before Start
> Part Names
∫ 1. Passcode
Set the pass code used to protect this unit. When you set a
pass code, the pass code screen is displayed when the
power is turned on or when restoring from display off. You
should create a pass code to protect your account if you are
going to use a network service.
1st Step : Passcode
Do you wish to use passcode
lock?
No
Yes
1. Enter any four digit number. If you made a mistake with
an entry, tap "
".
2. Enter the pass code again to confirm.
0 If you enter the wrong pass code three times, a message
appears asking if you want to initialize the unit's settings.
Note that even if the settings are initialized, the copied
music files are not deleted.
∫ 2. Wi-Fi
Set to use network services such as TuneIn Radio on this
unit.
> Initial Setup
> Playback
2nd Step : Wi-Fi
Do you wish to setup Wi-Fi?
No
Wi-Fi
Choose a network...
SSID 1
SSID 2
Other...
Push Button
Wi-Fi can be connected in the following two ways.
Selecting SSID:
1. Tap the SSID of the access point you want to connect
from the SSID displayed.
0 If the SSID of the access point is not displayed, tap
"Other..." in the SSID list and follow the on screen
instructions to configure.
2. After tapping the field for entering the password, enter
the password of the access point, then tap "Connect".
For details on how to enter text, refer to "Entering text"
(P30).
3. "
" is displayed on the status bar on the screen when
Advanced Setup | Supplementary Information | Others
the connections are complete.
Using the push button:
0 The access point needs to have an automatic setting
button.
1. Tap "Push Button" on the screen and press the automatic
setting button on the access point.
0 The operation of the automatic setting button depends
on your device. Refer to the instruction manual of your
device for instructions.
Yes
2. "
" is displayed on the status bar on the screen when
the connections are complete.
En
7
Publicité
