Télécharger Imprimer la page

Heco AURORA 200 P Mode D'emploi page 9

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 14
Dear Heco Customer,
Congratulations on your fine new loudspeakers and thank you very much for choosing Heco! You have made an excellent choice.
The high-quality speakers produced by Heco are renowned all over the world.
Please study the instructions and information below carefully before using your new loudspeakers.
IMPORTANT SAFETY PRECAUTIONS
• Please read through the instruction manual carefully before starting to use the device. This manual contains important
information concerning operation and safety aspects. It is imperative you observe all of the information. Keep the
manual in a safe location.
• WARNING NOTICES: All of the warning symbols on the device, accessories and in the instruction manual itself must be adhered to.
• E XPOSURE TO HEAT: Only operate the device and accessories in a temperature range from 10°C to 40°C.
The device should not be positioned near heat sources (heaters, ovens, radiant heaters, naked flames, etc.). When setting up
close to an amplifier a minimum distance of 10 cm must be maintained. No naked flame sources, such as lighted candles, should be
placed on the device. Pay attention to a sufficient ventilation of the device. The device may not be covered, e.g. by drapes, curtains.
Maintain a distance of 20 cm to walls.
EFFECT OF MOISTURE: The device should not be exposed to dripping or splash water. Neither should it be used to support
vases or other containers filled with liquid. Do not expose the device to water or high levels of humidity. There is a danger of
electric shock. In the event of contact with moisture or liquids remove the mains adapter immediately.
FOREIGN MATERIAL: Ensure that no foreign material enters through the device openings and into the interior. This could trigger
short circuits and even result in electric shock and fire.
CLEANING: Please use a soft, dry cloth with no cleaning agents, sprays or chemical solvents, as these could damage the surfaces.
ELECTRICAL CONNECTION: Please note the voltage levels on the information signs. The mains adapter for the device should
only be operated with the voltage and frequency values specified on the signs.
LIGHTNING PROTECTION/PREVENTIVE MEASURES: If the device is not going to be used for a prolonged period (e.g. when
on holiday), it should be disconnected from the mains by removing the plug. The device should also be disconnected from the
mains in the event of a thunderstorm. Doing this will prevent damage caused by lightning and overvoltage.
MAINS CABLE: The mains cable must always be suitable for operation and it should only ever be laid out in a manner that
prevents it from being trodden on. It should not be pinched by objects either, as this can damage the cable. When using plugs
and power strips it must be ensured that the cable is not kinked at the point where it emerges from the socket. Do not connect
or remove the mains cable with damp hands.
The mains plug is used as the disconnecting device. Disconnecting devices shall remain readily operable.
Do not endanger the safety of plugs with reverse polarity protection or a ground connection. A plug with reverse polarity
protection has 2 contacts with one wider contact. A plug with a ground connection has 2 contacts and a third contact that
functions as a ground connection. The third contact is for your safety.If the supplied cable is not compatible with your socket,
please ask an electrician to replace the unusable cable.
OVERLOAD: Sockets, power strips and extension cables should not be overloaded. Observe the rated values on the sockets
and extension cables. If an overload occurs, there is a risk of electric shock and fire.
SETTING UP: Please read the installation instructions. The device should only be positioned or mounted on a solid surface and
not on moving base frames, otherwise there is a risk of injury.
Only use attachments/accessories specified by the manufacturer.
RISK OF SWALLOWING BATTERIES:
1. Do not ingest the battery, Chemical Burn Hazard, The remote control supplied with this product contains a battery.
If the battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to death.
2. Keep new and used batteries away from children.
3. If the battery compartment does not close securely, stop using the product and keep it away from children.
4. If you think batteries might have been swallowed or placed inside any part of body, seek immediate medical attention.
DAMAGE THAT MUST BE RECTIFIED BY A SPECIALIST:
If any of the following damage occurs, disconnect the speaker from the mains immediately and contact a specialist to conduct the
repair work:
• The device should not continue to be operated if there is visible damage to the mains cable. A damaged cable should not be
repaired,
but must be replaced.
• Damage to the mains socket at the device.
• If moisture or water has entered the device or foreign objects have fallen into the device.
• If the device has fallen and the housing is damaged.
• If the device does not work properly, even though all of the information in the instruction manual has been observed.
Only those subsequent alterations approved by the manufacturer may be conducted. Only original spare parts should be used for repair.
After conducting any repairs the safety of device should be checked to ensure it is functioning correctly and safely.
Repairs must always be conducted by qualified specialists, as you might otherwise be exposed to dangerous high voltage levels or
other hazards.
9

Publicité

loading