Publicité
GENERAL INSTRUCTION
Check that seals (between the appliance and the gas container) are in place and in good condition before connecting to the
gas container.
Do not use the appliance if it has damaged or worn seals.
Do not use a device that leakage, deteriorated or malfunctioning.
This appliance should be used in sufficiently aerated places in accordance with regulations in force. The volume of air needed
for proper combustion and to prevent formation of dangerous unburned gas mixtures is 2 m³ / h per kW.
The appliance is designed to work in a horizontal position and with any inclination (360°) after a warm up for 20-30 seconds.
For long use it is recommended a maximum inclination of 60° of the device, to avoid excessive heating by refraction.
The appliance should be operated away from flammable materials and at a distance of 70 cm from furniture, walls and ceilings.
Gas containers shall be changed in a well ventilated location, preferably outside, away from any sources of ignition, such as
naked flames, pilots, electric fires and away from other people.
If there is a leak on your appliance (smell of gas), take it outside immediately into a well ventilated flame free location where
the leak may be detected and stopped. If you wish to check for leaks on your appliance, do it outside. Do not try to detect leaks
using a flame, use soapy water.
CAUTION: accessible parts may become very hot. Keep young children away from the appliance.
When the equipment is not in use must be stored upright, in suitable places, protecting it from degradation risks, the place must
be well ventilated and kept away from children.
Smoking is prohibited during assembling operation and all operations of the unit.
IGNITION
Open the gas regulator a quarter of a turn (in the "ON" direction) and press the ignition button. If you notice anything unusual
during operation, turn the device off immediately.
During long periods of operation, it is normal for the lower part of the cartridge to cool down.
Close the gas regulator (in the "OFF" direction) after using the device.
Accessible parts may become very hot. Wait to cool completely to avoid the risk of burns. Keep out of reach of children.
To regulate the rate, turn right (to decrease) or left (to increase) the handwheel of the burner.
Moreover, the rate can be regulated by turning (with only protecting gloves) the ring on the burner.
CARTRIDGE REPLACEMENT
The cartridge must be replaced in a ventilated area, preferably outside, away from open flames, pilot flames, electric and away
from other people.
Make sure that the valve is closed and the burner is off and cold before removing the gas cartridge.
Screw on the cartridge and ensure the burner is blocked: a valve inside stops the gas leakages.
Screw the new cartridge only by hand for not damaging the thread.
Briefly open the gas regulator and check whether gas escapes.
Using the new cartridges in a cold device can cause the flame to change. It will soon return to its normal shape.
Check the good condition of the seals before using a new cartridge.
Proceed as described in paragraph "IGNITION".
The cartridge must not be abandoned in the environment but in a safe place. Do not pierce the cartridge. Do not throw the
empty cartridge into fire.
MAINTENANCE
To clean the body of your appliance, use a cotton wad soaked in warm water and soap. Never use abrasive products. To clean
the burner, use a soft brush. Do not modify the appliance. It's dangerous to bring modification on device, remove or disassemble
its components or use components which are not approved by the manufacturer, all of this causes the cancellation of warranty
and manufacturer's responsibility.
REPAIR
All questions of the departments services must be formulated to: KEMPER – Via Prampolini 1/Q – 43044 Lemignano di
Collecchio (PR) – Italy – Tel. +39 0521 957111 – Fax +39 0521 957195 – www.kempergroup.it –
info@kempergroup.it
Wir danken Ihnen für den Kauf eines unserer Produkte. Es wird geraten, diese Gebrauchsanweisung aufmerksam zu lesen: Sie enthält
wichtige Informationen über die Sicherheitsbestimmungen beim Gebrauch und der Instandhaltung des Geräts. Es wird empfohlen, dieses
Dokument aufzubewahren, um es in Zukunft zu Rate ziehen zu können.
SICHERHEITSHINWEISE
Bitte lesen sie diese Gebrauchsanweisung, um sich mit dem Gerät vertraut zu machen, bevor die Gaskartusche montiert wird.
Bewahren sie diese Gebrauchsanleitung, um die später wieder nachzulesen. Verwenden sie in einem gut belüfteten bereic -
kategorie: direktdruck butan-propan. Dieses Gerät funktioniert ausschließlich mit KEMPER-Ventilgaskartuschen Art.-
575,576,580. Es kann gefährlich sein, andere Gaskartuschen zu verwenden. Die Verwendung anderer Gaskartuschen könnte
gefährlich sein.
ALLGEMEINE GEBRAUCH
Bevor der Apparat mit der Gaskartusche verbunden wird, kontrollieren, dass Dichtungen vorhanden und diese in gutem
Zustand sind.
Bei beschädigten oder abgenutzten Dichtungen, den Apparat nicht benutzen.
Verwenden Sie kein Gerät, das Gas verliert, oder veraltet ist oder schlecht funktioniert.
DT istr 1060_07/2012_Rev. 11_12/2020
5/20
Publicité
