Publicité
Les langues disponibles
Les langues disponibles
INSTALLING THE DOOR HANDLE
1. Locate the screw holes on the inside of the door and carefully pull the rubber gasket out to
expose them completely.
2. Align the door handle with the screw holes. Loosely attach the rst screw and washers. Attach
the second screw and washers, tightening fully, and then tighten the rst set. Do not overtighten,
as this could damage the handle and the door frame.
3. Return the door gasket to its original position, using a at screwdriver to gently push it into
place if needed.
gasket
locker washer
screw
REMOVING SHELVES
1. Pull the shelf out as far as it will go.
2. Using a slim stick or at head screwdriver, press the plastic strip on the left side up and pull the
left side of the shelf slightly outwards. Press the plastic strip on the right side down and pull the
right side of the shelf slightly outwards.
3. Carefully remove the shelf.
WARNING
To avoid damaging the door gasket, make sure the door is
completely open when removing shelves from the cabinet.
stainless steel
handle
at washer
door frame
8
LOADING THE WINE CELLAR
Your wine cellar was designed to hold up to 112 standard Bordeaux bottles, 7 on each shelf.
Larger and irregularly shaped bottles can be accommodated by removing shelves, which will
reduce the total capacity.
top view
For best results when loading the wine cellar:
- Spread the bottles out evenly so the weight is not concentrated in one area.
- Do not group bottles at either the top or bottom of the cabinet.
- Make sure the bottles do not touch the interior walls of the cabinet.
CONTROL PANEL
1. Power ON/OFF : Press and hold for 3 seconds to power the wine cellar on or o .
2. °C / °F Selector : Touch to change the temperature display between Celsius and Fahrenheit.
3. Set / Change Temperature : Touch to display the current programmed temperature and enter
temperature setting mode. After 5 seconds without a button being pressed, the display will
change back to the actual interior temperature.
4. Temperature Display : LED display shows either the selected temperature (in temperature
setting mode) or actual interior temperature.
5. Temperature +/- : During temperature setting mode, touch + to increase and - to decrease by
1 degree from a minimum of 5° to a maximum of 20°. The control panel will automatically lock
after 3 minutes without a button being pressed. Press and hold the + and - buttons at the same
time for 3 seconds to unlock.
6. Light ON/OFF : Touch to turn the interior light on or or o . The light will also turn on automati-
cally when the door is opened.
9
Publicité
