VWR avantor 471-1307 Manuel D'instructions page 10

Changing over door hinge
Change over the door hinge (e.g from right hinged to left hinged)
Caution: at least 2 trained staffs are needed to proceed this operation
• For Model 471-1307 & 471-1308
Step 1 Step 2
Step 1. Unscrew the right lower hinge (Caution: the door must be hold during this process) and then
remove the door
Step 2. Move the pin from the right upper hinge to the left one
Step 3. Install the pin onto the left hole of left lower hinge
Step 4. Move the door stopper at the right bottom of the door to the left; meanwhile move the sleeve
onto the left hole
Step 5. Hold the door and insert the left upper hinge into the shaft hole at the upper left side, then
insert the left lower hinge into the shaft hole at the lower left side, and then screw the left lower hinge
Step 6. Move the handle from the left side to the right side
• For Model 471-1309 & 471-1310
Step 1 Step 2
Step 1. Unscrew the front grid at the bottom
Step 2. Unscrew the right lower hinge and then remove the door (Caution: the door must be hold
during this process)
Step 3. Move the pin from the right upper hinge to the left one
Step 4. Install the right lower hinge back on its original place, then remove the pin on it then rotate the
door up side down.
Step 5. Unscrew the left lower hinge, and install the pin on it
Step 6. Hold the door and insert the left upper hinge into the shaft hole at the upper left side, then
insert the left lower hinge into the shaft hole at the lower left side, and then screw the left lower hinge
Step 7. Install the front grid at the bottom
Step 8. Move the handle from the left side to the right side
Step 3
Step 3 Step 4
7
Step 4
Step 5&6
Step 5 Step 6
Step 7 Step 8