Publicité
Les langues disponibles
Les langues disponibles
•
Fuel and oil are dangerous and highly flammable chemicals. If they become inflamed, extinguish the fire with a
dry powder extinguisher.
•
Do not spill fuel or smoke near the machine.
•
Always turn off the engine before refuelling.
•
Always refuel in well-ventilated areas. And never with the engine running, or hot.
•
If a fuel leak is found, do not start or run the engine until the leak has been repaired.
•
Make sure the fuel cap is properly closed.
•
Fuel stored in the carburetor for long periods of time can cause a hard start and may also lead to further repairs
and maintenance.
•
Always store fuel in approved containers.
MAINTENANCE, TRANSPORTATION AND STORAGE SAFETY
•
Check that all safety features are installed and in good condition.
•
Do not force this machine. Using the right machine for the right type of work will allow you to work better and
safer.
•
Always keep the machine clean, especially the fuel tank, its surroundings and the air filter.
•
Attention! Attention! After the engine has stopped, the muffler will be warm.
•
Carry out regular maintenance on the machine. We recommend that maintenance and repairs not described in
this manual be performed only by the Official Technical Service.
•
Before adjusting or repairing the machine, stop the engine and remove the spark plug wire. These safety
precautions reduce the risk of accidentally starting this machine.
•
Always make motor adjustments with the unit supported on a flat, clear surface. And never when the unit is in
operation.
•
Check that moving parts are not misaligned or jammed, that there are no broken parts or other conditions that
could affect the operation of the machine. Whenever it is damaged, repair it before use.
•
Keep cutting instruments sharp and clean.
•
Follow the instructions for lubrication, tensioning and chain change accessories. An incorrectly tensioned and
greased chain can break and increase the risk of recoil.
•
Keep the handles of this machine dry and clean.
•
If the machine starts to vibrate strangely, turn it off and examine it for the cause. If you do not see the reason,
take your machine to the Official Technical Service. Vibrations are always a sign of a problem on the machine.
•
Reduce the engine speed when turning off the engine, if the engine is equipped with a fuel shut-off valve, turn
off the fuel when the engine has stopped.
•
When transporting, hold the chainsaw by the front handle with the machine off, the chain and sword covered
with the cover and at a distance from the body parts. When storing the chainsaw, always cover the sword with
the cover.
•
Store tools out of the reach of children.
UNINVITED REACTIONS WHILE OPERATING WITH THE CHAINSAW
•
Always be careful when cutting with the chainsaw and be aware of any unexpected reaction forces. There are
three unforeseen reaction forces that occur on a chainsaw: rebound, forward pull and recoil.
REBOUND
•
If an object is touched with the cutting chain in the area of the tip of the sword while it is running. Contact of the
chain on the tip of the sword can cause an unforeseen reaction force that can push the tip of the sword upwards
generating a rotating movement that can cause the chain's sword to collide with the user. This reaction can result
in loss of control of the machine and severe personal injury.
63
EN
Publicité
