Samsung WF363 Serie Mode D'emploi page 32

troubleshooting and
information codes
INFORMATION CODES
Information codes may be displayed to help you better understand what is occurring with your washer.
CODE SYMBOL MEANING
32_ troubleshooting and information codes
WF361_363_365-02832J-03_EN.indd Sec8:32 WF361_363_365-02832J-03_EN.indd Sec8:32
Unbalanced load prevented your
washer from spinning.
Door is open when washer is
running.
Your washer failed to lock the
door.
Water temperature control
problem.
(Heater Control problem)
Your washer has tried to fill but
has not reached the proper water
level.
The door will not unlock.
Motor not running properly.
Your washer is not draining.
It can also mean that the unit
senses a small clog while draining.
Your washer has tried to fill but
was unsuccessful.
Check if the hot water supply
hose is connected.
The hot/cold water hose
connection is not correct.
Electric service was lost when the
washer was running.
SOLUTION
Redistribute the load, press the Start/Pause
Button.
Close the door tightly and restart the cycle.
If the code reappears, call for service.
Close the door tightly and restart the cycle.
If the code reappears, call for service.
Call for service.
Call for service.
Make sure the door is firmly closed.
Push the Power button to turn off your washer,
then turn it on again. If the code reappears, call
for service.
Restart the cycle by pressing the Start/Pause
Button. If the code reappears, call for service.
First, clean the drain filter. Then do the
following.
1) Turn off the unit and turn it on again.
2) Select only the Spin Cycle.
3) Press the Start/Pause to drain the water.
Clean the debris filter.
If it still does not drain, call for service.
Make sure the water faucets are open all the
way. Check for kinked hoses.
Check the inlet screens on the fill hoses.
If you use a Flood Safety Device, then please
remove the device and connect the water hoses
directly to the unit.
You must connect the hot water supply hose
because hot water is supplied by the Auto
Temperature Control (A.T.C.) function if the
temperature of the cold water is lower than 59 °F.
Please connect the hot/cold water hose
correctly.
Restart the cycle by pressing the Start/Pause
Button.
2012-08-20 2012-08-20 7:03:43 7:03:43