Casselin CAS10C Mode D'emploi page 14

5. INSTALLATION AND USE
5.1 Safety instructions
ELECTRICAL HAZARD
Danger due to electric current!
• No contact with heat sources should take place with the electrical cord.
• The cord should not hang over the edge of a table or counter.
• The device must be properly connected and comply with the regulations in force.
WARNING
While operating, the device can reach high temperatures. To avoid burns and accidents, do not use the
device if it is malfunctioning, and do not use non-original spare parts.
ELECTRICAL HAZARD
Danger due to electric current!
If incorrectly installed, the device can be dangerous and cause injury. Before any installation, check the data
of the electrical network. Connect the device only when there is compliance. The device must be unpacked
and fully checked before connection by a professional.
5.2 Use
WARNING
The setting up of the device installation and maintenance should only be carried out by professionals.
• Do not leave the appliance running without watching it.
• During use, your hands must be dry.
• Do not move or tilt the device during operation.
MANUAL
Remove the product from its packaging.
Fix the device to the wall with the fixing kit, it is advisable to fix your sterilization cabinet at least 1.30
meters from the ground, preferably in an accessible and clean place. Your decontamination cabinet must
operate in a vertical position, regardless of the room in which it is installed.
After cleaning the knives, place them on the grill
Then manipulate the side button of the timer to launch a sterilization cycle by setting it from 0 to 120 min
(recommended 1h30), a sterilization cycle begins immediately.
The bacteria are sterilized by ultraviolet radiation.
The cycle ends at the end of the timer when the light goes out.
If the door is opened during a cycle, the cycle must be set again to 2 hours after closing the door. When a
cycle is complete, the knives are sterile and ready to use.
EN