Warning Light - Honeywell MN09 Série Mode D'emploi

USE & OPERATION (CONTINUED)
FUNCTION BUTTONS (CONTINUED)
POWER CONTROL
• Dehumidifying Mode
The Power Control turns the unit on and off. When switched on the unit will start on Auto mode.
Air is dehumidified as it passes through the unit, without being in full cooling mode. If room tempera-
ture is higher than 25°C (77°F) fan speed can be adjusted; otherwise fan speed is preset to LOW.

WARNING LIGHT

Note: If the unit will be used mainly as a dehumidifier, do not connect the exhaust hose and let the
Condensed water may accumulate in the unit. If the internal tank becomes full, the Warning Light will
warm air return in the room. Continuous drainage is then necessary and more efficient (refer to
shine red and the unit will not operate until the unit has been drained.
Continuous Draining).
• Fan Mode
MODE INDICATOR LIGHT
For air circulation without air conditioner cooling.
Cooling Mode - Blue
Dehumidifying Mode - Orange
Fan Mode - Green
FAN SPEED CONTROL
3 settings: High, Medium and Low.
2 settings: High and Low.
TEMPERATURE AND TIME SETTING INDICATOR DISPLAY
The indicator displays:
TIMER CONTROL
• Current temperature.
While the unit is turned on, press the timer button then press the ▼ or ▲ to select the number of hours
• Thermostat setting while changing the temperature.
you would like the unit to continue to run. The unit will turn off automatically.
• Timer hours during Timer setting.
AUTO TURN OFF:
When ambient temperature is higher than 50°C / 122°F, the indicator shows "HI". When ambient
While unit is running, press the press the ▼ or ▲ button to select the number of hours you want the unit
temperature is lower than 0°C / 32°F, the indicator shows "LO".
to run in air conditioning mode.
AUTO TURN ON:
Note:
When unit is in a standby mode (plugged in with power light on), then press the ▼ or ▲ button to select
• Once thermostat or timer has been set the indicator will continue to display ambient temperature after
the number of hours until you want the unit to automatically start running.
5 seconds.
• When setting the thermostat or timer the indicator will be flashing.
TEMPERATURE / TIMER SET CONTROLS
After switching the air conditioner off, you must wait 3 minutes before switching it back on
• Used for adjusting the timer and thermostat.
again.
• The default display is room temperature.
• In cooling mode, when ▼ or ▲ button is pressed, the set temperature is displayed and may be
adjusted. After 10 seconds the display will revert back to room temperature. Temperature is only
adjustable in cool mode. The time is adjustable between 1~24 hours.
Note: By pressing both ▼/ ▲ set buttons at the same time, the display will toggle between Celsius
and Fahrenheit.
WARNING LIGHT
Condensed water may accumulate in the unit. If the internal tank becomes full, the Power Control light
illuminate will flash and the unit will not operate until the unit has been drained (refer Water Condensation
Drainage).
After switching the air conditioner off, you must wait 3 minutes before switching it back on
again.
*Applicable for models with Heating feature only.
EN 5
Warning Light will