FORM FIT SD 13S14 Instructions D'installation page 2

5. Clean all the mounting areas aggressively with the surface cleaner to remove any fingerprints, oils or waxes that may be on the surface.
Take care to not contaminate the surface after cleaning. Any surface contaminants will reduce the adhesion of the 3M tape.
6. Starting at the pedestal end, peel the first 2-3 cm (1/2-1 1/2 inches) of the protective backing from the adhesive tape on the flange of the
visor. Press the visor into place as determined above. Work forward, removing the protective backing from the tape and pressing the
part into place. Use extreme care to place the visor as prescribed. Once the tape is in place it is nearly impossible to remove it.
7. Gently lift visor away from door frame so the pull tab on the adhesive pedestal is accessible. Pull the protective backing from the
pedestal and firmly press the visor onto the door frame. Using the wooden "wet-out" stick supplied, apply pressure to the surface of the
adhesive pedestal. This will ensure there is maximum contact between the adhesive tape and door frame.
8. Once the visor is in place press down hard along the entire flange area to make sure that the adhesive tape is fully adhered to the
vehicle.
9. Repeat steps 5-8 for the remaining visors. When installing the rear door visors, start at the adhesive pedestal end of the visor and
work back.
Clean the visors with a mild soap and water solution or plastic cleaner only. Do not use chemicals or solvents. Periodically
check to make sure the visors are secure. Avoid using automatic car washes.
Made In Canada
SD 13S14
"Wet Out"
Rev0.Jan 5, 2018 Page 2 of 4