FORM FIT SD 13S14 Instructions D'installation

Installation Instructions
3M Double-sided Body Moulding Tape
- Already applied to the visor
2 – Surface Cleaner
4 – Adhesive Pedestals
4 – # 6 x 5/8" Flat Head Screws
4 – Pins
1– Wooden "Wet-out" stick
Attention
: This product uses a 3M adhesive that requires installation and curing temperatures of 15° to 43°C (60° to 110°F) for 1 hr to
develop maximum adhesion to the vehicle surface. Failure to install this product at the proper temperature or allow adequate
curing time before use is not covered under warranty.
1. Insert a pin through the hole in the side visor and into the adhesive backed pedestal. Note: See illustration below for pedestal
orientation. Maintain slight pressure on the pin, to ensure proper seating of the components, while simultaneously tightening the
screw. Repeat for other three pieces. Do not remove the protective backing.
2. The visors mount to the window frames of the doors. Ensure those areas are clean and dry.
3. Start with the driver's side front door of the car.
4. To understand how and where the visors will fit, hold the front door visor up to the car. Align the top edge of the visor flush with the top
of the door frame. Center the visor on the door, front-to-back. The visor is 3-4mm shorter than the door so there will be a 1-2mm gap
at the mirror base and at the rear edge of the door. These gaps allow for expansion on hot days. Repeat this step for the rear door
visor. There will also be a 1-2mm gap at each end. See illustration.
SD 13S14
Side Window Visors
SD 13S14
Nissan Rogue 2014 - up
Phillips Screwdriver # 2 Long Shaft
Tape Measure
Masking Tape
Pedestal Orientation
Protective Backing Pull Tabs
Rev0.Jan 5, 2018
Adhesive
Pedestal
Orientation
Page 1 of 4