Page 1
Customer Service is available Monday-Friday - 9 a.m. to 5:30 p.m. EST (except holidays) Store behind closed doors. Library Base NOTE: THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. Briarbrook Collection | Model 430075 PLEASE READ AND KEEP FOR FUTURE REFERENCE. Sauder.com English pg 1-22 Français pg 23-25 Español pg 26-28...
Page 2
Table of Contents Assembly Tools Required Part Identification No. 2 Phillips Screwdriver Hardware Identification Tip Shown Actual Size Hardware Usage Guide Assembly Steps 6-22 Français 23-25 Español 26-28 Safety 29-30 Warranty Page 2 www.sauder.com/service 430075...
Page 3
LEFT DOOR (1) LEFT END (1) LEFT DRAWER SIDE (1) RIGHT DOOR (1) RIGHT END (1) RIGHT DRAWER SIDE (1) LEFT FRAME (1) LEFT BACK (1) DRAWER BACK (1) RIGHT FRAME (1) RIGHT BACK (1) DRAWER BOTTOM (1) 430075 www.sauder.com/service Page 3...
Page 4
1-9/16" PAN HEAD SCREW - 2 1-3/16" FLAT HEAD SCREW - 4 1/2" HEX HEAD SCREW - 8 1/2" PAN HEAD SCREW - 6 BLACK 1/2" FLAT HEAD SCREW - 12 SILVER 1/2" FLAT HEAD SCREW - 24 Page 4 www.sauder.com/service 430075...
Page 5
The arrow in the HIDDEN CAM must point Arrow toward the hole in the edge of the board. Hidden Cam Hole Insert the CAM SCREW or CAM DOWEL into the HIDDEN CAM. Tighten the HIDDEN CAM. 430075 www.sauder.com/service Page 5...
Page 6
Step 1 Look for this icon. It means a video assembly tip is available at www.sauder.com/service/tips Find the numbered video or scan the QR code. å Assemble your unit on a carpeted floor or on the empty carton to avoid scratching your unit or the floor.
Page 7
NOTE: Be sure the LARGE WOOD DOWELS in the BACKS insert into the BOTTOM. Arrow Caution Do not stand the unit upright without the BACK fastened. The unit may collapse. 1-9/16" PAN HEAD SCREW (2 used in this step) 430075 www.sauder.com/service Page 7...
Page 8
Step 3 å Turn six CAM SCREWS (4) into the ENDS (C and D). å Push four HIDDEN CAMS (3) into the ENDS (C and D). Arrow Page 8 www.sauder.com/service 430075...
Page 9
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS. Push the black lever and pull the SLIDE from the RAIL. Use these holes. BLACK 1/2" FLAT HEAD SCREW (6 used in this step) Open end Open end 430075 www.sauder.com/service Page 9...
Page 10
Fasten the RIGHT END (D) to the BOTTOM (B) and BACK fastened. The unit may collapse. RIGHT BACK (F). Tighten three HIDDEN CAMS. å NOTE: Be sure the LARGE WOOD DOWELS in the RIGHT END insert into the BOTTOM and BACK. Page 10 www.sauder.com/service 430075...
Page 11
å Fasten the LEFT END (C) to the BOTTOM (B) and LEFT BACK (E). Tighten three HIDDEN CAMS å NOTE: Be sure the LARGE WOOD DOWELS in the LEFT END insert into the BOTTOM and BACK. 430075 www.sauder.com/service Page 11...
Page 12
Fasten the TOP (A) to the ENDS (C and D) and BACKS (E and F). Tighten six HIDDEN CAMS. å NOTE: Be sure the LARGE WOOD DOWELS in the TOP insert into the ENDS and BACKS. Page 12 www.sauder.com/service 430075...
Page 13
å Peel the PADS from the PAD CARD (8) and apply them to the bottom of the FRAMES (R and S). 1/2" HEX HEAD SCREW (8 used in this step) 430075 www.sauder.com/service Page 13...
Page 14
Turn three CAM SCREWS (4) into the DRAWER FRONT (H) and one CAM SCREW (4) into the DRAWER BACK (L). å Push four HIDDEN CAMS (3) into the DRAWER SIDES (J and K) and DRAWER BRACE (N). Arrow Arrow Page 14 www.sauder.com/service 430075...
Page 15
BACK (L). Use four 1-3/16" FLAT HEAD SCREWS (15). å Slide the DRAWER BOTTOM (M) into the grooves in the DRAWER SIDES (J and K) and DRAWER BACK (L). 1-3/16" FLAT HEAD SCREW (4 used in this step) Groove 430075 www.sauder.com/service Page 15...
Page 16
Fasten the DRAWER FRONT (H) to the DRAWER SIDES (J and K) and DRAWER BRACE (N). Tighten three HIDDEN CAMS. å NOTE: Be sure the WOOD DOWEL in the DRAWER BRACE inserts into the DRAWER FRONT. Surface with HIDDEN CAMS Be sure the DRAWER BOTTOM inserts into the DRAWER FRONT groove. Page 16 www.sauder.com/service 430075...
Page 17
Fasten a PULL (6) to the DRAWER FRONT (H). Use two 1/2" PAN HEAD SCREWS (17). BLACK 1/2" FLAT HEAD SCREW (6 used in this step) Open end Open end 1/2" PAN HEAD SCREW (2 used in this step) 430075 www.sauder.com/service Page 17...
Page 18
The drawer will push in hard until it is all the way in, then it will slide in and out easier. å Peel APPLIQUES from the APPLIQUE CARD (13) and stick them onto each visible HIDDEN CAM. Page 18 www.sauder.com/service 430075...
Page 19
Step 14 å Fasten the HINGES (11) to the DOORS (P and Q). Use eight SILVER 1/2" FLAT HEAD SCREWS (19). SILVER 1/2" FLAT HEAD SCREW (8 used in this step) 430075 www.sauder.com/service Page 19...
Page 20
Fasten a PULL (6) to each DOOR (P and Q). Use four 1/2" Hinge PAN HEAD SCREWS (17). å See the next step for DOOR adjustments. SILVER 1/2" FLAT HEAD SCREW (16 used for the HINGES) 1/2" PAN HEAD SCREW (4 used for the PULLS) Page 20 www.sauder.com/service 430075...
Page 21
å To adjust the DOORS in or out (depth), loosen the mounting Adjusting screw (horizontal) screw one turn and move the DOORS in or out, as needed. Tighten the mounting screw after making adjustments. 430075 www.sauder.com/service Page 21...
Page 22
NOTE: Please read the back pages of the instruction booklet for important safety information. å This completes assembly. Clean with a damp cloth. Wipe dry. And to celebrate, why not share your success story at sauder.com or b s . 1 5 l Page 22 www.sauder.com/service...
Page 23
Modèle 430075 Base de bibliothèque Utilisez les instructions d’ a ssemblage en français avec les NOUS CONTACTER EN PREMIER schémas étape par étape du manuel d’instruction en anglais. AVANT D'EFFECTUER TOUT RETOUR AU MAGASIN. Chaque étape en français correspond à la même étape en Nous faisons de notre mieux pour nous assurer que votre meuble anglais.
Page 24
Séparer les COULISSES D'EXTENSION (2) des GLISSIÈRES D'EXTENSION (1) comme l'indique le schéma ci-dessous supérieure. Faire attention car les pièces sont graissées. Fixer les GLISSIÈRES D'EXTENSION (1) aux EXTRÉMITÉS (C et D). Utiliser six VIS TÊTE PLATE 13 mm NOIRES (18). Page 24 www.sauder.com/service 430075...
Page 25
Le tiroir offrira une certaine résistance jusqu'à ce qu'il soit complètement inséré dans l'élément, il glissera ensuite sans difficulté. Décoller les APPLIQUÉS de la FICHE D'APPLIQUÉS (13) et coller les sur chaque EXCENTRIQUE ESCAMOTABLE. 430075 www.sauder.com/service Page 25...
Page 26
RIEL DE EXTENSIÓN ..........2 su referencia futura. Si necesita ponerse en FONDO .................1 CORREDERA DE EXTENSIÓN ......2 contacto con Sauder en EXTREMO IZQUIERDO ..........1 EXCÉNTRICO ESCONDIDO ......16 cuanto a esta unidad, EXTREMO DERECHO ..........1 BIELA DE EXCÉNTRICO ........16 refiérase al número...
Page 27
TORNILLOS NEGROS DE CABEZA PERDIDA de 13 mm (18). NOTA: Debe apretar cada TORNILLO unas vueltas antes de apretar cualquier tornillo firmemente. Separe las ALMOHADILLAS de la TARJETA CON ALMOHADILLA (8) y aplique las al inferior de los MARCOS (R y S). 430075 www.sauder.com/service Page 27...
Page 28
Separe las APLICACIONES de la TARJETA CON APLICACIONES (13) y aplique las sobre cada EXCÉNTRICO ESCONDIDO visible. Page 28 www.sauder.com/service 430075...
Page 29
à mortelles. Les téléviseurs peuvent être un téléviseur. cet effet. particulièrement lourds. De plus, le poids et l’emplacement du tube image ont tendance à rendre les téléviseurs instables et enclins à tomber vers l’ a vant. 430075 www.sauder.com/service Page 29...
Page 30
Además, el peso y la ubicación del tubo de imagen tienden a causar la inestabilidad de televisores y propensa a volcarse hacia adelante. Page 30 www.sauder.com/service 430075...
Page 31
à compter de la date d'achat la première fois et qui sont signalés à Sauder dans les limites de couverture de la contre tout défaut de matériaux ou de fabrication des composantes de mobilier Sauder.
Page 32
BEFORE MAKING ANY RETURNS TO THE RETAILER. So, how did it go? Dear Valued Customer: Thanks so much for choosing Sauder® furniture. I hope the Set a world record for speed? purchase and assembly process was a positive experience Feeling good about yourself? and you feel good about the furniture you just built.