Télécharger Imprimer la page

Honeywell TP30WK Mode D'emploi page 14

Déshumidificateur portatif et déshumidificateur portatif intelligent
Masquer les pouces Voir aussi pour TP30WK:

Publicité

Les langues disponibles

Les langues disponibles

USE & OPERATION (CONTINUED)
FUNCTION BUTTONS
POWER CONTROL
Press
to switch the dehumidifier ON or OFF.
HUMIDITY CONTROL SETTING
When the unit is switched ON, the Display Screen shows the current humidity percentage.
Press
or
to select your preferred humidity level. The humidity is adjusted in increments of 5%
by pressing
or
90% RH. Ten seconds after setting the preferred humidity setting, the display will revert back
to displaying the current humidity.
IMPORTANT: There is a 5% threshold when the desired humidity setting has been reached. The
compressor will shut off once the relative humidity is 5% lower than your desired setting. The fan will
continue to run for up to 3 minutes to cool the motor and will then shut off. Operation restores once
the relative humidity is 5% higher than your desired setting.
Recommended Settings: It is recommended to leave the unit running at 30% humidity at
High Fan Speed during the first 2 to 3 days until damp odors are removed. After a few days when
the Relative Humidity has been reduced to a more comfortable level, press
higher RH% that maintains a comfortable humidity level thereafter. A recommended healthy
humidity level is between 40% and 50%.
NOTE: The humidity sensor senses current humidity in the surrounding area. It is normal for about
a 5% variance above or below the actual relative humidity in the room. Therefore, if there is a slight
variance, the unit may sometimes operate slightly longer or shorter than the set RH% level.
CONTINUOUS MODE
To activate the Continuous Mode, press the
The
indicator light will be illuminated. The unit will run continuously.
WATER TANK FULL ALERT
When the Water Tank is full, the
The compressor will shut off, and the fan will stop for a few minutes. To switch off the
light, empty the water tank and when replacing it ensure the tank is secured properly in place.
IMPORTANT: Do not place the Water Tank on the floor when full. In case of an uneven base which may
cause the tank to spillover.
. The adjustable Relative Humidity (RH) range is between 30% RH to
indicator will be illuminated. The unit will beep for 3 seconds.
button on the Display Screen until
EN
13
or
to choose a
CO CO
appears.
indicator

Publicité

loading