BraunAbility A Série Manuel D'installation page 29

Installing the cassette
1
Raise the pallet using a forklift. Position the cassette between the brackets, at least
10 mm from the rear axle.
2
Adjust the mounting slides so they correspond with the respective brackets. Fasten
the cassette to the brackets using the screws and washers removed in an earlier
step. Use the rearmost two holes. When attaching a footstep, an accessory that can
be ordered separately, use the same mounting slide. The third hole is used only in
this instance.
3
Lower the pallet and remove it. Retighten the screws to 50 Nm. Then retighten all
the bracket fastenings onto the vehicle chassis.
Example of brackets illustrated
Position the cassette
between the brackets
under the vehicle.
Fasten with screws and
washers on both sides
Min 10 mm
The slots, on rear vehicle
specific brackets, are for tilt
adjustment of the cassette.
Always align the cassette with
the ground, not the vehicle.
29 29
A-Series
EN EN