Stadler Form Robert Mode D'emploi page 13

Info: Once the desired air humidity is reached, the appliance stops and
the display blinks. The current air humidity is then measured approx.
every 30 minutes (the fan runs for 1–2 minutes). Should the measured
current air humidity fall below the set value, the appliance begins to
humidify again.
6. The humidification performance depends on the speed of the fan. If no
specific mode has been set, the speed level may be changed: Press the
«Speed» button (if necessary, first activate the display with a hand mo-
tion). The display will blink. Now select the speed level 1, 2, 3 or 4 (Turbo)
by repeatedly pressing the «Speed» button. The levels are displayed us-
ing horizontal bars (e.g. 1 bar = level 1).
7. Robert is equipped with 3 different pre-programmed modes: «Auto
Mode», «Night Mode» and «Clean Mode». Press the «Mode» button (if
necessary, first activate the display with a hand motion). The display
will blink. Select the mode by repeatedly pressing the «Mode» button:
– «Auto Mode»: Robert automatically maintains the air humidity level at
45 %. The lower the current air humidity level is, the higher the speed
level of the fan will automatically be set (e.g. under 30 % = level 3, from
31 % to 40 % = level 2, from 41 % to 45 % = level 1).
– «Night Mode»: The display illumination is reduced to minimum and the
fan speed is set on level 1. The desired air humidity level and the fan
speed can be adjusted manually.
– «Clean Mode»: This mode is used in order to clean and descale the
appliance. Here the evaporator discs rotate but the fan does not run.
Thus no air is blown into the room. After 20 minutes in cleaning mode,
the appliance stops and the «Clean Mode» display blinks (see «Cleaning»
chapter).
8. You can use Robert to disperse fragrances in the room. It must be
emphasised to please use fragrances extremely sparingly because an
excessive dosage can result in malfunctioning of and damages to the
appliance. In order to use fragrances, remove the water tank (5) and pull
the fragrance container (15) out of the appliance. Let the fragrance drip
directly onto the cotton pad in the fragrance container. Add a maximum
of 1–2 drops of fragrance into the fragrance container.
Tip: In order to change the fragrance, pull the fragrance container out of
the appliance, remove the cotton pad and clean the container with soap.
Now you may insert a new cotton pad (commercially available) and add
drops of the desired fragrance.
9. As soon as the «No Water» symbol (14) lights up, the appliance must
be refilled with water. To do this, remove the water tank (5) and fill it
with clean, cold tap water. After replacing the water tank, the appliance
automatically resumes operation after a few seconds.
10. If you would like to refill the water during operation, you may remove the
water tank and refill it. The appliance will continue to operate using the
water still in the appliance for at least 30 minutes. As long as the water
tank is replaced within this period of time, the appliance can continue its
service without interruption.
Important information
Humidification with an air washer takes some time. An air washer works
according to the evaporation principle. In this process the air only absorbs
as much water as it needs at the current temperature (self-regulating