Publicité
Les langues disponibles
Les langues disponibles
Stake down the tent and screen room
14
through the corner and side webbing
loops.
setting up the awning
A. Assemble the awning poles by
19
unfolding each section.
B. Place the end of the pole with
the pin through the grommet hole
at the corner of the awning.
C. Place the ring end of the guy line
over the pole pin located at the top
of the awning. Place the awning
cap over the pin.
A. Stake the bottom loop of the guy line (bottom
20
portion of plastic slider) to the ground with a peg.
Repeat for all awning guy lines.
B. Adjust the length of the guy lines by pushing the
plastic slider upwards until the line is tight.
attaching the rainfly
Drape the rainfly over the tent. The side that says "Vehicle Side" goes towards the vehicle.
15
Attach the rainfly to the clips found at the bottom corners of the tent. Tighten the straps
16
and secure the Velcro tabs around the poles.
At the top corner of the rainfly, locate the elastic strap with the plastic hook. Secure it to
17
the steel loop on the tent pole. Repeat on the opposite corner.
19c
Stake the rainfly guy lines to the ground.
18
To install the gear loft, place each
21
corner hook of the gear loft into
the loop located on the ceiling of
the tent.
20B
20A
Publicité
